System Operation - Altana BYK byko-drive S Instrucciones Resumidas

byko-drive S

4 System Operation

Starting the byko-drive S
• Connect the power supply (rear of instrument).
• Turn on Power switch (rear of instrument).
• Setup drawdown parameters using touch screen.
• Begin drawdown by pressing the Start button.
Preparing a drawdown
• Level the instrument using the adjustable feet.
• Use the Setup screen to select drawdown parameters.
• Select a drawdown substrate and place it on the vacuum plate.
• Turn on the external vacuum source (if using a glass plate version fix the
substrate in place with the paper clamp).
• Place the drawdown bar or rod of your choice in front of the push-bar.
• If needed, place the weight on top of the bar or rod.
• Add your coating in front of bar or rod.
• Press the Start button.
• At the end of travel, remove the drawdown bar or rod.
• Press the Return button.
• Turn off external vacuum source and remove substrate.
Downloading the documentation
Following documents can be downloaded from our website:
https://www.byk-instruments.com/p/2139
Document Type
Safety Instructions
Short Instructions
Operating Instructions
Go to the article details page for an automatic film applicator and open the
section Downloads.
8
Document No.
285 024 578
285 025 844
285 025 845 E
BYK-Gardner GmbH
No. of Languages
24
8
English
285 025 844 - 2106