Tabla de contenido
Publicidad
Dystrybucja systemów Jablotron: MBS SYSTEMS s.c.
❥
If you want to use the Nanny in more than one cot, you may use additional pads (item number
BM-02D, sold separately) and then just attach the control unit to the pad in the cot your baby is using.
You can also attach two pads to a single control unit so that a larger area of the cot can be monitored,
this is particularly useful for older infants who are more likely to move around the cot. Both of the pads
connect to the alarm unit via a splitter (supplied).
Using the Nanny BM-02 for twins:
sensor pad in each cot. The cots must not touch. For the purposes of monitoring using the Nanny, the
twins
must not share the same cot
2. Inserting batteries into the control unit:
❥
The battery compartment is located on the rear of the control unit.
❥
To open the battery compartment lid, use the palm of your hand and slide it off.
❥
Use 2 new AA size alkaline batteries.
❥
The polarity of the batteries is clearly marked in the battery compartment.
❥
Close the lid and turn the switch to position I.
❥
The indicators will flash in sequence and you will hear a beep.
❥
Switch the unit OFF again (position 0).
❥
If there is no beep after turning ON, check the batteries.
3. Securing the control unit:
❥
If securing the control unit to the bars of the cot then use the fastening strap (supplied)
❥
Alternatively the alarm unit can be fixed to a wall using the wall-mount holder (supplied).
❥
Once attached, the unit should be clearly visible to you and should not be covered.
❥
We recommend that you position the unit out of the reach of older infants.
4. Connecting the pad's cable to the control unit:
❥
Wrap the cable around a bar of the cot in such a way that there is no loose cable for the infant to
pull on. Insert the cable connector into the alarm unit until you hear a click.
❥
Any excess cable should be pushed firmly under the mattress.
❥
Should you wish to position the alarm unit in a different room to the one where the cot is then you
can use the 5-meter extension cable (supplied). Do not use more than one extension cable.
❥
When using two pads in a cot, use the cable splitter supplied.
❥
To disconnect the cable from the unit – press the connector tab towards the cable and pull.
S W I T C H
Green indicator (smiley face)
Red indicator (unhappy face)
Red battery indicator
B M -0 2 Na n n y Ba by Re spir at io n Mo n ito r
Each baby must have its own cot with a separate control unit and
even if they each have their own Nanny within the cot.
A N D
I N D I C A T O R S
Switch
– position 0 = OFF, I = ON
– a short flash indicates a breath or a movement of the baby
– flashes when there is an ALARM
– flashing indicates low batteries
13
www.sklep-jablotron.pl
M F V 5 21 04 N AV- 03 2.0 4
Publicidad
Tabla de contenido
