Pack Contents; Fitting The Shelves - Polar UA017 Manual De Instrucciones

EN

Pack Contents

The following is included:
• POLAR Refrigerator
• Shelf guide (2 per door)
• Shelf (1 per door)
• Glass panel set
• Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 5cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position.

Fitting the Shelves

1. Place one set of shelf guides on either side of
the cabinet at the desired height.
2. Slide the shelf into place.
3. Repeat for the remaining shelves.
4
UA017-UA018-UA019_ML_A5_v1_20220211.indb 4 UA017-UA018-UA019_ML_A5_v1_20220211.indb 4
Fit Glass Panel (FT367/FT368/
FT369) onto counter unit (FT281/
FT283/FT285)
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the collar for the
grub screw faces inwards.
2. Slot the two side panels into the collars, with
the holes in the glass at the top.
Note: Ensure the screw hole furthest from
the edge of the panel goes to the back of
the appliance.
3. Screw a grub screw into each collar to secure
the panels.
Note: Ensure the soft end of the
grub screw is the end making
contact with the glass.
Do not over-tighten the grub screws as it
will result in the glass breaking.
4. Slot the rear panel into the collars, with the
holes in the glass at the top.
5. Screw a grub screw into each collar to secure
the panel.
6. Slot the plastic plugs into each of the holes.
7. Screw the brackets to the inside of each pane
using the bolt assemblies.
Note: Ensure the short end
of the bolt assembly is on the
outside of the panels.
8. Place the top panel onto the brackets, ensuring
all holes line up.
9. Insert the plugs and attach the top panel to
the brackets with the bolt assembly.
Bracket
Glass Panel
Bolt Assembly
Plug
Bolt Assembly
2022/2/11 10:32 2022/2/11 10:32