Rs16000H; Main Controls; Rs16000B - dBTechnologies RS16000TR Manual Del Usuario

English
English

Main controls

RS16000H

5
2
3
4
1
1 On/Off and MUTE key
1
On/Off and MUTE button
2 Display
2
3 IR interface
4 Battery cover
3
5 Capsule protection
Battery cover
4
6 Battery housing
Mic cover
5
6 Battery compartment
Main controls

RS16000B

+
8
+
1.5V AA
1.5V AA
7
3
CAUTION, RISK OF EXPLOSION IF BATTERY
IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USE BATTERIES ACCORDING
TO THE INSTRUCTIONS.
Made in ITALY
1
On/Off and MUTE button
1 On/Off and MUTE key
2 Mini XLR connector
Mini XLR connector
2
3 Battery cover
4 Cover release
Battery cover
3
5 Status LED
6 Display
Open buttons
4
7 IR interface
8 Battery housing
status LEDs
5
RS16000TR
6
7
Battery compartment
8
6
Display
IR port
6
2 5 1
display
IR port
RS16000H is a handheld transmitter equipped with
interchangeable dynamic cardioid capsule. An adapter
ring (included) can make it compatible with SHURE
capsules. The figure next to this paragraph shows the
main items:
• 2 AA type batteries are required for the use. The
relevant housing [6] can be opened by unscrewing
the cover [4].
• The IR interface [3] is hidden by the cover [4].
• Once the radio microphone has been turned on with
key [1], press the same key for approx. 1 second to
enable/disable the MUTE function. Shortly press key
[1] to move through the pages
• The display [2] shows name, frequency, MUTE
indication, battery level, capsule gain and
transmission power
• Configuration and monitoring are carried out
through the display of the RS16000R receiver after
synchronisation with this device (see next chapter)
• The gain can be adjusted only after the
synchronisation via the control on the RS16000R
receiver
• It is recommended to remove the batteries when the
radio microphone is not used for a long time
RS16000B is a bodypack transmitter. Thanks to a mini
XLR connector it can be used not only with a lavalier
microphone or a headset, but also with a musical
instrument (e.g. electric guitar). The figure next to this
paragraph shows the main items:
• 2 AA type batteries are required for the use. The
relevant housing [8] can be opened by releasing the
locks [4].
• The IR interface [7] is visible on the radio
4
microphone side.
3
• Once the radio microphone has been turned on with
key [1], press the same key for approx. 1 second to
enable/disable the MUTE function
• The display [6] shows name, frequency, MUTE
indication, battery level, audio gain and transmission
power. Shortly press key [1] to move through the
pages
• Configuration and monitoring are carried out
through the display of the RS16000R receiver after
synchronisation with this device (see next chapter)
• The gain can be adjusted by directly acting on the
two "+" "-" buttons inside the compartment [8].
• It is recommended to remove the batteries when the
radio microphone is not used for a long time
Cod. 420120285 REV. 1.0
31