Remote Control - dBTechnologies RS16000TR Manual Del Usuario

English English

7. REMOTE CONTROL

The software that allows controlling RS16000TR from remote through PC is "dBTehnologies
Wireless Manager". It allows accessing all RS16000TR receiver parameters in remote.
Once installed on PC:
• it allows controlling 1 RS16000TR through USB connection
• it allows controlling several RS16000TR devices through ETHERNET connection (see chapter
"MULTI-MICROPHONE SYSTEMS")
To use the software:
1) download it and install it on PC
2) connect the HUB800 section of RS16000TR using a cable with USB connectors (front) or with
RJ45 connectors (Ethernet cable, rear side), see also the figures next to this paragraph.
3) when launching the software the connection is shown immediately if through USB, otherwise
with the function CONNECTION -> DISCOVERY if through ETHERNET
"dBTechnologies Wireless Manager" features:
• an ID is automatically assigned to each receiver
• switch to the data writing page (fig. 2) by clicking on the monitoring page of the receiver (fig.
1)
• every change made from the PC is displayed on the HUB800 screen in real time.
In case of ETHERNET connection with:
• the connection to the PC is carried out directly or through router
• in case of DHCP setting the IP address is assigned directly by the router
• it is possible to enable the manual assignment option in which the user can configure the IP
address and subnet Mask. In this case, bear in mind that the PC must be in the same subnet
with different IP address. E.g.:
Fig. 2
RS16000TR
HUB800 IP: 192.168.0.1
Netmask: 255.255.255.0
PC IP: 192.168.0.2
Netmask: 255.255.255.0
Fig. 1 Fig. 2
Cod. 420120285 REV. 1.0
39