Optional Accessories - Makita DF010D Manual De Instrucciones

Drilling operation
First, turn the adjusting ring so that the pointer points to
the marking. Then proceed as follows.
Drilling in wood
When drilling in wood, the best results are obtained with
wood drills equipped with a guide screw. The guide screw
makes drilling easier by pulling the bit into the workpiece.
Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a center-punch and hammer at
the point to be drilled. Place the point of the bit in the
indentation and start drilling.
Use a cutting lubricant when drilling metals. The
exceptions are iron and brass which should be drilled dry.
CAUTION:
Pressing excessively on the tool will not speed up
•
the drilling. In fact, this excessive pressure will only
serve to damage the tip of your bit, decrease the
tool performance and shorten the service life of the
tool.
There is a tremendous force exerted on the tool/bit
•
at the time of hole break through. Hold the tool
firmly and exert care when the bit begins to break
through the workpiece.
A stuck bit can be removed simply by setting the
•
reversing switch to reverse rotation in order to back
out. However, the tool may back out abruptly if you
do not hold it firmly.
Always secure small workpieces in a vise or similar
•
hold-down device.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery.
Using the tool as a hand screwdriver
008718
Switch off the tool.
Move the lock button to the locked position A.
Turn the tool.
All manuals and user guides at all-guides.com
NOTE:
MAINTENANCE
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.

OPTIONAL ACCESSORIES

If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
NOTE:
9
Use the tool with a fastening torque less than 5 Nm
•
(3.7 ft•lbs).
This use is convenient
•
screwdriving.
Do not use the tool for work requiring excessive
•
force, such as tightening bolt M6 or bolts greater
than M6 or removing rusted screws.
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
Drill bits
•
Screw bits
•
Socket bits
•
Bit piece
•
Makita genuine battery and charger
•
Plastic carrying case
•
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
for checking the
or attachments are
Only use accessory or