Removing Mineral Deposits; Troubleshooting - Fridja f1000 Manual Del Usuario

ENGLISH

REMOVING MINERAL DEPOSITS

Depending on the water you use, minerals and sediment may collect in the
steamer and affect the free flow of steam. To reduce this, we recommend
using demineralised or distilled water.
To remove mineral deposits, please follow this procedure.
1. Turn the unit off and unplug from the power outlet.
2. Remove the hose and telescopic pole from the base.
3. Drain the water from the water reservoir and empty the water
storage tank.
4. Mix a solution of 50% vinegar and 50% water or citric acid.
5. Slowly pour the solution into the hose connector or pour into the
water reservoir until full.
6. 6. Plug the appliance in to a suitable power outlet and turn on
7. any power outlet switch if necessary. Turn the unit on and leave to
steam for 2-3 minutes, or until the water reservoir is empty.
8. Drain the water reservoir of any residual solution by removing the drain
plug and allowing the liquid to drain into a sink or bucket.
9. Pour clean water in the hose connector and water reservoir and then
drain.
10. Repeat the rinsing procedure until the vinegar odour disappears.
11. Re-assemble the appliance and operate as usual.
There are two sachets inside your box for your first two cleans.
16
All manuals and user guides at all-guides.com

TROUBLESHOOTING

f1000 FRIDJA PROFESSIONAL GARMENT STEAMER
Problem Reason
Unit fails to steam, Steamer is not
light does not turn on plugged in
Unit fails to steam There is substantial
mineral deposits
throughout the unit
Water storage tank
is empty
'Gurgling' sound from Condensation
hose, steamer head or within the hose
base unit
Steam is intermittent Substantial mineral
deposits in the unit
Solution
Plug the unit into a
suitable power outlet
and turn on if applicable
Follow the remove
mineral deposits
procedure
Fill the water storage
tank
'Gurgling' is normal
during the steaming
process. If there is
excessive gurgling,
extend the hose to allow
excess water to drain
back into the water
storage tank
It is normal for the unit
to periodically stop
steaming for a few
seconds
However if this occurs
for longer periods,
follow the remove
deposits procedure
17