Genesis GAPCS203 Guia De Inicio Rapido

RIP CUTTING TRACK SYSTEM
For use with GENESIS TrakRunner™ Plunge Circular Saw GPCS535KM.
FIG 2
FIG 1
FIG 5
SPECIFICATION
Track length (Assembled): 49 1/2" (1260 mm)
Includes: (3) Tracks, (2) Connectors, (2) G-Clamps and (1) Hex key, See FIG 1
ASSEMBLY AND ADJUSTMENT
Connecting the Tracks
1. The track connector has two pieces. Put the two pieces together as shown in FIG 2.
2. Place the two tracks on a flat surface. Connect the two tracks by inserting the connector into the slots on both tracks as shown in FIG 3.
Make sure the connecting piece has the screws facing up..
3. Join the two tracks as closely as possible as shown in FIG 4.
4. Tighten the two screws on the connector using Hex key provided.
5. Use the same procedure to connect the third track or optional additional tracks.
OPERATION
G-Clamp
Two G-Clamps are provided to secure the track on the workpiece. See FIG 5 for how to use the G-Clamp with the track.
Mounting the Saw on the Track
Once the track is secured on the workpiece, mount the plunge saw in the track by inserting the edge of the base plate into the slot on the track.
See FIG 6.
Cutting with Rip Cutting Track (FIG 7)
IMPORTANT!
The workpiece must have a flat surface. Otherwise the cutting process will not be stable and will lead to poor cutting accuracy.
• Stabilize the track on the workpiece.
• Mount the plunge saw in the track by inserting the edge of the base plate into the slot on the track.
• Align the indicator line on the base plate to the cutting line marked on the workpiece.
• Secure the track by using the G-Clamps provided with the track system.
• Plug the tool into a power source. Switch on the tool and wait for a moment for the blade to run up to speed. Press the plunge release button,
plunge the blade into the material slowly and gently, but firmly. Then push the tool forward along the track. (Never draw the tool backwards.)
• Once the cut has been finished, lift the tool from the work surface before switching off.
• The rubber will be cut off during first cutting. This is normal.
TOLL-FREE HELP LINE
For questions about this or any other GENESIS™ Product, please call Toll-Free:
www.genesispowertools.com
Or visit our web site:
FIG 3
FIG 6
888-552-8665
.
ENG
GAPCS203
FIG 4
FIG 7
©Richpower Industries, Inc. All Rights reserved
Richpower Industries, Inc.
736 Hampton Road, Williamston, SC 29697
Printed in China, on recycled paper
2014.12.V01