Becken BGS4505 IX Manual De Instrucciones página 14

Connection and Security:
1.
Prior to installation, ensure that the local distribution conditions
(nature of the gas and gas pressure) and the stove specifications are
compatible.
2.
The stove specifications are stated on the label (or data plate).
3.
This stove is not connected to a combustion products evacuation
device. It must be installed and connected in accordance with current
installation regulations. Particular attention must be paid to the
relevant requirements regarding ventilation.
4.
Please remove the silicon gasket from the gas inlet before
connecting the gas.
5.
Fit the clamp to the hose. Push one of the hose until it goes to the
end of the pipe.
6.
For the sealing control, ensure the control buttons in the control
panel are closed, but the gas cylinder is open. Apply some soap
bubbles to the connection - if there is any gas leakage, soap bubbles
will form.
7.
The stove should be placed in a well ventilated place and should
be installed on flat ground surface.
8.
Re-inspect the gas connection.
9.
When placing your stove on its location, ensure that it is at the
counter level. Bring it to the counter level by adjusting the feet if
necessary.
10. Do not pass your stove's gas hose and electrical cable through
heated areas, especially behind the stove. Do not move the gas
connected stove. Given that any force applied shall loosen the hose,
gas leakage may occur.
11. Please use a flexible hose for the gas connection.
12. Connect your stove to an LPG in the shortest way possible and
without any leakage. The min. length is 40 cm and max. is 125 cm.
13. When checking for gas leakages, never use a flame like a lighter,
matches, cigarettes or similar.
14
Becken FW-6402GPZW_FW-6402GPZH_ID 4505.indd 14 19/08/2019 12:27