Publicidad
Idiomas disponibles
Idiomas disponibles
CLAMP
1. Attach clamp bracket to back side of power strip
using three machine screws. Tighten using Phillips
screwdriver until secure. (See Figure 1)
Figure 1
2. Find desired position along the edge of desktop
and secure clamp by turning knob clockwise.
(See Figure 2)
NOTE: Clamp option is compatible with
desktops 1/2-3" thick.
Figure 2
DESKTOP
1. Attach desktop bracket to back side of power strip
using three machine screws. Tighten using Phillips
screwdriver until secure. (See Figure 3)
NOTE: Bottom half of bracket should extend
away from power strip.
Figure 3
PAGE 2 OF 6
MOUNTING
2. Find desired position along edge of desktop. Using
3. Attach power strip to edge of desk using six wood
Machine
Screws
Clamp Bracket
UNDER DESK
1. Attach under desk bracket to back side of power
2. Find desired position under desktop. Using a 1/8" drill
3. Secure power strip to underside of desktop using
Machine
Screws
Desktop Bracket
1-800-295-5510
uline.com
a 1/8" drill bit, pre-drill six holes using bracket as a
template.
screws. (See Figure 4)
Figure 4
strip using three machine screws. Tighten using
Phillips screwdriver until secure. (See Figure 5)
Figure 5
Machine
Screws
bit, pre-drill three holes using bracket as a template.
three wood screws. (See Figure 6)
Figure 6
Wood Screws
Under Desk Bracket
Wood Screws
0721 IH-9497
Publicidad
