Optional Casters - Uline H-6920 Manual Del Usuario

1. Flip the table back over onto a smooth, non-marring
surface. Remove adjustable feet from legs using a
flat head screwdriver. (See Figure 7)
NOTE: User may need to use a rubber mallet or
hammer to assist.
2. Hold caster base and rotate nylon bushing
clockwise. This will cause the rubber piece to
expand. (See Figure 8)
3. Expand the rubber enough so that it will fit snugly
into the tube leg.
PAGE 3 OF 9

OPTIONAL CASTERS

Figure 7
Nylon Bushing
Rubber Expansion
Piece
Caster Base
Figure 8
1-800-295-5510
uline.com
4. With caster fully inserted into the leg, turn clockwise
until caster is secured to tube leg. (See Figure 9)
NOTE: If too loose, pull out caster and tighten
further. Repeat step 2.
Figure 9
Tube Leg
0122 IH-6919