Wall Mounting (Optional) - Uline H-2920 Guia De Inicio Rapido

PAGE 2 OF 6

WALL MOUNTING (OPTIONAL)

Figure 4
1-800-295-5510
uline.com
NOTE: Mounting hardware is intended for drywall.
1. Three mounting holes, located on 16" centers, are on the
back of the mail sorter. (See Figure 4)
2. On the wall where the cabinet is to be mounted, mark
three points 16" apart in a level, straight line.
NOTE: If points are located on a wall stud, you will
not use the drywall anchors. Otherwise, anchors
must be used.
3. Pre-drill the three holes using a 1/4" drill bit for the drywall
anchors or 1/16" drill bit if using screws only.
4. Insert the drywall anchor into 1/4" pre-drilled hole and
screw in tightly.
5. Insert a screw (into the anchor, if used, or directly into
pre-drilled hole) and turn screw until almost tight, leaving
a 1/16" gap. Repeat this procedure for each hole.
6. Hang the cabinet on the wall, ensuring that all three
holes are mounted on the screws.
7. Once mounted, tighten the screws by reaching in
through the front of the mail sorter.
0421 IH-2920