Tandberg Data DLT-V4 Manual Del Usuario página 2

DLT-V4 Tape Drive Quick Start Card
2 For SCSI — Connect an active LVD/SE terminator onto one
end of the SCSI cable, if the tape drive is the last or only
device on the SCSI bus. See
came with the SCSI host bus adapter already has a
terminator built into it, do not use an additional terminator.
N : If the tape drive is not the last or only device on
OTE
the SCSI bus, make sure the last device on the SCSI
bus is properly terminated
whenever you use the tape drive.
Figure 3 Connect the Cables
and Secure the Cover
SCSI Tape Drive — Rear
SCSI cable
(with terminator)
5 Secure the tape drive in the selected server or workstation
with the appropriate mounting screws. See
Contact the computer manufacturer if the server or
workstation uses mounting rails for internal tape drives.
6 Install the cover on the server or workstation. Connect the
power cables to any attached peripheral devices.
7 Power on any attached peripheral devices.
8 Power on the server or workstation and allow its operating
system to start.
N : Turn to the last page for information on
OTE
additional resources.
All manuals and user guides at all-guides.com
2. If the SCSI cable that
figure
and is powered on
SATA Tape Drive — Rear
SATA power
cable
Drive power
cable
figure 3.
3 For SCSI — Connect the SCSI cable to the tape drive and to
the SCSI host bus adapter. Connect the power cable to the
tape drive. See
figure 3.
4 For SATA — Connect one end of the SATA data cable to the
tape drive and the other end of the SATA data cable to the
SATA host bus adapter. Connect
or drive power cable to the tape drive. See
cable
C :
Connect only one power cable to the drive;
AUTION
connecting both the SATA power cable
power cable to the tape drive may damage the drive.
SATA
data cable
or
Tabletop Tape Drive
Inspect and Prepare the Tape
Drive
1 Inspect the shipping box and contents of the box for
damage. If you find any damage, report it to the shipping
company.
N : Save the packing materials in case you need to
OTE
move or ship the tape drive. You must ship the tape
drive in the original or equivalent packing materials
to preserve your warranty.
2 Change the SCSI ID for the tape drive, if necessary. See
4. Use a small screwdriver or ballpoint pen to press
figure
the buttons above or below the SCSI ID to increase or
decrease the number. For complete instructions, see the
DLT-V4 Product Manual .
either the SATA power
figure
and drive
Drive power
cable
0
3.
0
2