Celestron 94035 Manual De Instrucciones página 9

also "pinch to zoom" if you have a touchpad or use your mouse's
scroll wheel to zoom in and out. Use the slider that appears at the
bottom of the graph to find a particular time range.
ENVIRONMENT GRAPH
Select "Environment Graph" from the Dew Heater menu to bring up
the Environment Graph window (Figure 18). You can also access
the Environment Graph directly from the Overview screen by clicking
on the shortcut arrow icon next to the word "Environment" on the
left side of the Overview screen. This graph shows the ambient air
temperature, humidity, and calculated dew point over time. The air
temperature and dew point use the °C temperature scale on the left
of the graph. Humidity uses the % humidity scale on the right of the
graph. Each color line on the graph represents a different value. If
you wish to change the color for a value, mouse over it and right-click.
You can hide a value from the graph by clicking on the circle to the left
of the value's name on the graph. To re-enable its line on the graph,
simply click on the circle again.
Fig 18
Environment Graph window
To "zoom in" to a specific time range on the graph to see more detail,
use the "+" and "-" circles at the bottom right of the graph. You can
also use "pinch to zoom" if you have a touchpad or use your mouse's
scroll wheel to zoom in and out of time ranges. Use the slider that
appears at the bottom of the graph to find a particular time range.
To change temperature units from degrees Fahrenheit (default)
to degrees Celsius, use the "Settings" selection from the Dew
Heater menu.
SETTINGS
The "Settings" selection from the Dew Heater menu brings up the
Dew Heater Settings window (Figure 19).
- Current Limit
Use the slider to set the maximum current for the power supply
l
you are using. If the power draw from the controller exceeds
Fig 19
Dew Heater Settings window
the set max current, the "Over Current" LED on the controller
enclosure's bridge will light up. If this occurs, you will need to
reduce the power draw by turning down or turning off devices
connected to the controller. Alternatively, you can use another
power supply capable of providing more current. If you do this,
make sure to adjust the current limit accordingly.
- Temperature Units
Change the units of temperature in CPWI using the °C and
l
°F buttons.
- Environment Sensor Recalibration
Use the "Start Recalibration" button to recalibrate the
l
environmental sensor. This heats the sensor to evaporate any
moisture that has accumulated on it. Recalibration helps provide
the most accurate sensor readings. It takes about 10 minutes
for the sensor to heat up and cool back down. We recommend
recalibrating the environmental sensor periodically, especially if
the sensor has not been used in a while or has been stored in
humid conditions. This will help provide the most efficient power
usage for the dew heaters.
If you check the ambient temperature or humidity during
n
recalibration, the display will report the values last
detected before recalibration began.
- LED Brightness
Set the brightness of the LEDs on the controller using the
l
slider. One is the dimmest setting, and ten is the brightest.
- Power Down on Disconnect
You can choose to power off all connected devices when you
l
disconnect the controller from CPWI. To do this, click the Enable
button. When you reconnect CPWI, all ports will turn back on.
ENGLISH | 9