LUND 68090 Manual Del Usuario página 11

All manuals and user guides at all-guides.com
GB
power cord or the plug is damaged, immediately disconnect it from the power supply and
contact an authorised service centre of the manufacturer for replacement. Do not use the
product with a damaged power cord or plug. The power cord or plug cannot be repaired and
must be replaced with a new one that is free of defects if these components are damaged.
Instructions for use
Disconnect the power cord plug from the power supply socket before fi lling the appliance's
tank with water or emptying it. When the appliance is in use, the soleplate is heated up to
a high temperature and steam is generated. Contact with soleplate or steam can lead to
serious burns. The water tank cover must always be properly closed when ironing. The
appliance must be used and placed on a fl at and stable surface. If the appliance is placed
on its base, make sure that the base is placed fi rmly. Do not use the appliance if it has been
dropped, if there are visible signs of damage or if it is leaking. Return a defective appliance to
an authorised service centre for repair before reusing it. When using the appliance, always
hold it by the handle. Never touch the appliance's soleplate. Do not iron clothes which are
on the body of the user or others. Using the appliance in such a manner will cause serious
burns. The steam outlet must never be pointed in the direction of people or animals. Pour
only clean tap water, demineralised water or distilled water into the appliance's tank. Do
not add any substances, e.g. perfume to the water. Such use is not in accordance with the
intended use and will result in damage to the appliance. Do not pour any liquids other than
water into the tank. Pour the water in and out only if the appliance's soleplate is completely
cooled down. When pouring in water, be careful and minimise water spills. Do not place the
appliance directly under the tap to fi ll the tank. Never immerse the appliance in water or any
other liquid. It is recommended to use a measure or funnel to pour water into the appliance's
tank. Do not use water from desilters of air conditioners, dryers or similar equipment. Never
place the appliance on its soleplate when it is connected to the power supply. During short
breaks in ironing and in order to cool the appliance down after fi nishing work, the appliance
should be placed on the supplied base.
APPLIANCE OPERATION
Preparation for the fi rst use
Remove the appliance from its packaging by removing all packaging components.
If the steamer's soleplate has been secured with a protective fi lm, remove it completely. Do not use sharp tools that could damage
the surface of the soleplate.
Open the water tank cover and fi ll in the tank with water. Close the tank cover. Grasp the steamer by the handle and turn it verti-
cally with the handle pointing downwards, and check that the water level is not higher than the "MAX" indicator on the water tank.
Place the steamer on the base (II) and plug the power cord into the socket.
Move the temperature controller to the "max" position. The power indicator lights up and the soleplate heats up. The end of the
heating up will be signalled by the power indicator going off . When the steamer heats up for the fi rst time, unpleasant smells, small
amounts of smoke and small particles can come out of it.
Once the steamer has fi nished heating up, grasp it by the handle and press the steam boost button a few times while holding the
appliance horizontally. All settlements will be removed from the steam delivery system.
The fi rst ironing is recommended to be carried out without any caps, on a cloth, so as to make sure that the steamer's soleplate
does not soil the ironed fabrics.
After the preparation is complete, start ironing or place the steamer in a vertical position, resting it on the base, unplug the power
cord from the socket and allow the steamer's soleplate to cool down on its own.
O R I G I N A L I N S T R U C T I O N S
11