Uline H-8166 Manual Del Usuario página 2

1. Bolt bottom shelf (with caster holes) to inside of posts
using 16 Phillips head bolts and 10 mm locknuts.
2. Bolt upper shelves to desired bolt hole locations
on posts using 16 Phillips head bolts and 10 mm
locknuts per shelf.
NOTE: If attaching handle to same bolt hole
locations on posts as an upper shelf, DO NOT
insert bolts into upper shelf until attaching
handle brackets. (See Steps 3–5)
3. Bolt one handle bracket (A) to outside of post at
desired bolt hole location, bolting through bracket
and post using 2 Phillips head bolts and 10 mm
locknuts.
NOTE: If attaching handle to an upper shelf,
bolts will need to go through brackets, posts
and shelf.
4. Insert handle (B) over raised section of handle
bracket (A). (See Detail 1)
5. Place second handle bracket into handle and bolt
to outside of post using 2 Phillips head bolts and
10 mm locknuts.
6. Turn cart over and align caster mounting brackets
(C) with bottom shelf bolt holes.
7. Align caster top plate holes with caster mounting
bracket holes. Attach casters by placing 16 hex head
bolts through the bottom shelf, caster mounting
brackets, and caster plates. Secure with 14 mm
locknuts. (See Detail 2)
NOTE: Extra Phillips Head bolts and 10 mm
locknuts may be included.
PAGE 2 OF 6
ASSEMBLY
Detail 1
1-800-295-5510
uline.com
B
C
Detail 2
A
B
A
Hex Head
Bolt
Bottom
Shelf
Caster
Mounting
Bracket
Caster Plate
Locknut
1020 IH-8166