ETI 504091120 Guía De Uso Y Cuidado

9" RECTANGULAR MARINE BULKHEAD WITH COLOR PREFERENCE
PACKAGE CONTENTS
Part Description
A Lens
B Fixture Base
AA Drywall Anchors
BB Wire Nut
CC Fix Screw (for mounting)
DD Fix Screw (for J-box)
EE Gasket
NOTE: Keep your receipt and these instructions for proof of purchase.
WARNING: Shut off the power at the circuit breaker or fuse panel before removing the old fixture, ballast, or fluorescent tubes.
NOTE: Stick the replacement label on the inner wall of the recessed housing before installation.
If you are unfamiliar with electrical installations, we recommend you contact a qualified electrician to do the installation.
INSTALLATION 1
Open the lens (A) from the fixture base (B) by screwdriver, and disconnect
1
the connector between PCB and the driver.
A
B
Put the Gasket (EE) on the back of fixture base (B). Drill 4 holes through the 4
3a
markpoints of fixture base (B), connect the AC wires and the driver wires by
wire nut (BB).
NOTE: AC wires should go through one of the 5 conduit entry holes on
the fixture base (B).
Conduit
(not included)
EE
Mark points
USE AND CARE GUIDE
Quantity
1
1
4
2
4
2
1
Connector
Φ 0.18in. (4.5mm)
BB
Conduit entry holes
B
®
A AA BB
B CC DD
Mark 4 holes position and drill holes using Φ0.26in.(6.5mm), insert the
2a
drywall anchors (AA) into the holes.
NOTE: Do not need drill holes on wooden surfaces.
7.48in. (190mm)
Align the holes on the fixture base (B) with the holes in the wall, and drill fix
4a
screws (CC) into the holes, lastly, silicone sealant (not included) around the 4 holes.
Assemble the lens (A) with the fixture base (B) after connecting the connector of
PCB and driver. Then tighten with lens screws. Apply silicone sealant (not included)
between the fixture and the wall.
CC
B
A
B
Model # 504091120
Part # MBRT-9IN-2LB-8-3CP-MV-WT
AND LUMEN BOOST
EE
Φ 0.26in. (6.5mm)
4.33in. (110mm)
AA
Connector
Silicone sealant
(not included)
Lens screw
TM