Publicidad
All manuals and user guides at all-guides.com
The safety belt must go under the lock-off, not over the
(21) -1
lock-off.
The safety belt must be locked into the buckle.
The load leg must be installed correctly with green
(21) -3
indicator.
5
Push the car seat down into the base
seat is secure, the car seat indicator shows green. If the car
seat is not secure, the indicator shows red.
Pull up on the car seat to be sure it is securely latched
into the base.
6
To release the car seat, pull the car seat up while squeezing
the car eat release button.
Installation with ISoFIX System
1
Unfold the load leg from storage compartment.
2
Fit the ISOFIX guides with the ISOFIX anchor points.
The ISOFIX guides can protect the surface of the vehicle
seat from being torn. They can also guide the ISOFIX
connectors.
3
Rotate the ISOFIX connectors 180 degrees until they are
pointing in the direction of the ISOFIX guides.
4
Line up the ISOFIX connectors with the ISOFIX guides, and
then click both ISOFIX connectors into the ISOFIX anchor
(27)
points.
Make sure that both ISOFIX connectors are securely
attached to their ISOFIX anchor points. There should
be two audible clicks and the colors of the indicators
on the both ISOFIX connectors should be completely
(27) -1
green.
Check to make sure the base is securely installed by
pulling on the both ISOFIX connectors.
5
Please refer to step 2 in section 'a. Installation with
3-point-belt' for adjustment of load leg.
27
(22)
, if the car
(23)
(24)
(21) -2
(18)
(25)
(26)
Publicidad
Capítulos
