SMC Networks SMC7004VBR Manual De Instalación Rápida página 19

SMC7004VBR_QS.joint.qxd 19/9/02
Chapter 4. Configuring Your Barricade
Now that you have successfully configured your computer and
retrieved your new network settings from your Barricade, you are
ready to configure the Barricade's settings for your LAN.
1. Open your Web browser (i.e., Internet Explorer or Netscape
Navigator) and click the stop button.
2. In the "Address" field type "http://192.168.2.1" and press
<ENTER>.
Note: For some browsers it may be necessary to include ":88" after
the management IP address. For example, http://192.168.2.1:88
3. The Barricade login screen will appear. Leave the Password field
empty and click on "Login." There is no password by default. For
security reasons, you should assign a password as soon as
possible. Note that the login password is case-sensitive.
12:43 pm Page 37
4. On the home page of the Barricade Web console, click "Setup
Wizard." The automated setup process of the Barricade will take
you through each step for setting up your gateway.
5. Select your time zone from the list.
6. Click on "NEXT," and the "Broadband Type" setup screen will
display.
There are three different general configurations for high-speed
Internet connections. You need to know about your Internet
connection to determine which configuration to use. You found
out most of what you need to know when you recorded your IP
settings in earlier steps. There are some guidelines to determine
which configuration you should use in the following section.
For PPTP setup refer to the section "Advanced Setup" in the
full manual.