Cleaning And Maintenance - Redmond SkyCoffee RCM-M1509S-E Manual Del Usuario

into the filter with coffee by 10 second periods with 10-second breaks during the function
operation. Thanks to that the flavour and aroma of the ready drink become more intense.
To enable the function in any mode of the appliance operation press "Strength' button.
indicator will light up on the panel. To disable the function repress the "Strength" button,
indicator will go out.
It is not recommended to use the strength adjustment button when making more than
10 cups of coffee as it may lead to the appliance overheating.
Control panel lock
The appliance is equipped with a control panel lock function to prevent misuse ("child lock").
1. To enable the lock in the standby mode press and hold down the "Strength" button
for several seconds. An audible signal will be heard, [ ] symbols will light up on
display. When pressing any button in the lock mode [ ] symbols will appear on display.
2. To unlock the control panel, again press and hold the "Strength" button until the
longer sound signal is heard. The ] [ symbols will be shown on the display.
Coffee brewing
1. Open the lid of the water tank and remove it by pulling upwards by the handle. Fill
the tank with clear water. Fill the tank with clean cold water not exceeding the
maximum mark and install it to the housing until tight. Close the lid.
2. Open the filter holder by pulling it by the lock to the left. Install the removable filter
into the filter holder. Add the ground coffee into the filter so that no less than a half
of the container was empty. Set the filter holder into the working position, by turning
it to the right until it clicks.
It is not recommended to tamp ground coffee in the filter. Use medium ground coffee,
suitable for the drip coffee makers. When making coffee from beans of different grinding,
the filter filling degree may be slightly different.
3. Set the jar onto the metal plate for heating. Plug in the appliance.
4. To brew coffee in the automatic mode press. The
5. After water tank is empty, the appliance will finish operation in coffee making mode
and switch to the mode of keeping the ready drink warm.
6. After the end of operation the appliance will make three audible signals and switch
into the standby mode, the indication will go out. To turn the appliance into the
standby mode manually, press "Start/Cancel".
III. CLEANING AND MAINTENANCE
Before cleaning please make sure the appliance is unplugged and has cooled down.
DO NOT wash the appliance under running water, immerse into water or wash in dish-
washer.
DO NOT use abrasives and chemically aggressive substances, sponges with hard coating
when cleaning the appliance.
8
All manuals and user guides at all-guides.com
indicator will light up.
Removable parts under running warm water after each use. Soft detergent can be used.
Clean the housing and metal plate for reheating when required.
During operation, depending on the composition of usable water, oxide spots and scale can
appear on the heating element and inner walls of the appliance. To remove it use special
nonabrasive cleansers for scale cleaning and removal from kitchen appliances.
Before repeated operation or storage completely dry all parts of the appliance. Store the
assembled appliance in a dry, ventilated place away from heating appliances and direct
sunlight.
During transportation and storage, do not expose the device to mechanical stress, that may
lead to damage of the device and/or violation of the package integrity.
Keep the device package away from water and other liquids.
IV. BEFORE CONTACTING SERVICE CENTRE
Problem Possible cause
Pump makes noise Empty water tank
Empty water tank
The appliance wasn't properly
cleaned after last use
The appliance is heavily clogged
Water doesn't flow
through
You use coffee of too fine
grinding
Coffee in the filter is too tamped
Coffee is too coarsely ground
Water runs too fast
There isn't enough ground cof-
fee in the filter
Appliance is not plugged in
Appliance doesn't
There is no power supply in the
function
electrical outlet
Plastic odour ap-
Appliance is new, the smell
peared during op-
comes out of protective cover
eration
Solution
Fill the water tank
Fill the water tank
Check the appliance cleaning according
to recommendations of the section

"Cleaning and maintenance"

We recommend you to use ground cof-
fee, intended for use in the coffee-
makers of this type
When adding coffee to the filter do not
apply too much force
Try to use fine ground coffee
Put more ground coffee into the filter
next time
Plug in the appliance to the working
outlet
The smell will disappear after a few
uses