Approved Channels - 3Com AP9552 Dual Band Manual Del Usuario

: There are no user-replaceable fuses or user-serviceable parts inside
the unit. If you have a physical problem with the unit that cannot be solved with problem
solving actions in this guide, contact your supplier.
: RJ-45 ports. These are RJ-45 data sockets. They cannot be used as
standard traditional telephone sockets, or to connect the unit to a traditional PBX or
public telephone network. Only connect RJ-45 data connectors, network telephony
systems, or network telephones to these sockets.
Either shielded or unshielded data cables with shielded or unshielded jacks can be
connected to these data sockets.
: To comply with FCC radio frequency (RF) exposure limits, a minimum
body-to-antenna distance of 20 cm must be maintained when the AP is operational.

Approved Channels

Use of this product is only authorized for the channels approved by each country. For
proper installation, select your country from the country-selection list.
To conform to FCC, Canada, EU and other country restrictions, your product as
shipped may be limited in the channels that are available. If other channels are
permitted your country, please visit the 3Com web site for the latest software version.
The Appendix A lists the Software Downloads information.
2 Mounting the AP
Unpacking the AP
Make sure that you have the following items, which are included with the AP:
One 3Com 9552 Access Point
Wall-mounting hardware:
One combined wall-mounting bracket and table-top stand
Four screws
Four wall anchors
Suspended ceiling bracket:
One ceiling bracket
One slider
Two screws
All manuals and user guides at all-guides.com
3