Charging the power station
The power station can be charged using an AC power cable, car charging cable, or solar panel.
1. AC charging
Connect the 3-pin connector of the AC power cable to the AC charging input port of the power
station, and attach the other end to the mains.
The standard charging time is about 5 hours. If AC fast charge is enabled, the charging time can be
shortened to about 2 hours.
Notes:
Please turn on the power station before AC charging.
The AC output is disabled when the power station is in AC charging.
2. DC charging
Charging with car charger
Connect the plug of the car charging cable to the 8mm DC input port of the power station, and
attach the other end to the cigarette lighter of the car.
Ignite to start the car, and the car's cigarette lighter port is energized to charge the power
station.
Charging with solar panel
Connect the solar panel to the power station according to two ways of connector: 8mm port or
Andersen port.
Notes:
The open-circuit voltage of the solar panel should be between 12 and 27V.
Supports up to 2 70mai portable solar panels in parallel.
The 8mm and Andersen ports of the power station cannot be connected simultaneously.
09