Switching The Appliance Off - Supra OASIS 1503 Manual Del Usuario

Cable housing
- Open the cable housing compartment by pulling on it.
- Remove the cable
Installation
- Respect the safety instructions.
- Unwind the power cable fully.
- Plug the appliance into a mains outlet.
- Stand the appliance on a level surface (never on a thick carpet).
Operation
- Thermostat operation
- Turn thermostat C (fig. 7) clockwise until it stops at maximum.
- Select the power by turning power knob B (fig. 7).
- When the room reaches the desired temperature, turn thermostat C anticlockwise until it clicks.
- The temperature has now been set. The radiator will automatically adjust to this temperature. If the
temperature drops below this setting, the radiator will automatically switch on until the set temperature
is reached.
- Power selection:
- Connect the appliance to the mains supply.
- Use the power knob to choose the heating level.
MINIMUM power:
- Select power I
- Turn the thermostat knob C until it is at the desired temperature.
MEDIUM power:
- Select power II
- Turn the thermostat knob C until it is at the desired temperature.
MAXIMUM power:
- Select power III
- Turn the thermostat knob C until it is at the desired temperature.
Power table
Power I
Power II
Power III
Anti-frost function
- Select the desired power and set the thermostat to the anti-frost position. To do this, turn the
thermostat anticlockwise to the minimum position.
- The appliance will switch on when the room temperature reaches approx. 5°C. This keeps the
temperature above 5°C and stops water pipes from freezing.

Switching the appliance off

- Turn the power knob to 0. The appliance stops heating.
OASIS 1503
Minimum
Medium
Maximum
OASIS 2003
600 W
900 W
1500 W
OASIS 2503
800 W
1200 W
2000 W
1000 W
1500 W
2500 W