Tabla de contenido
Publicidad
INITIAL USE:
Plug in the heater.
Switch on power using the switch (1) on the back of the
unit. When it's turned on, the heater will be standby
mode and display '- -'.
Press Button '2' to turn on the heater. L1 (Level 1) is
displayed which is half power or 1000 Watts. Pressing
the button again will put the heater back into standby.
Button '3' allows you to set an operating time from 0 –
24 hours. Keep pressing the button to set the running
time (indicated on the display on the front).
Button '4' increases the heating to L2 (Level 2), 2000 Watts which is full power.
These functions are also available using the remote control.
Note that there may be odour or vapour from the heater on initial use or if it has not been used for an
extended period. This is normal.
OPERATION BY REMOTE CONTROLLER:
The Herschel MALIBU can also be operated from the remote control supplied with the heater. Insert 2 x
AAA Alkaline batteries into the remote control.
TROUBLESHOOTING:
1. Check if the power cord is plugged into an electrical outlet, if not, plug it in.
2. Check there is power to the unit by seeing if the display is lit (any symbols).
3. Check for Error codes on the display:
E1 Error on Display:
L1, L2 shows in display, but no heat:
1. POWER BUTTON: Turns heater on or off.
2. UP BUTTON: Increases the temperature and timer level.
3. DOWN BUTTON: Decreases temperature and timer level.
4. TIMER BUTTON: Use to set the timer from 00 – 24 hours.
5. Adjust using buttons 2 & 3 to the number of hours you would
like to set.
6. LEVEL BUTTON: Use to adjust heat levels (L1-L2). Press the
Level button then use the up and down buttons (2 and 3) to
increase or decrease the heating level.
All Herschel remote controls have the same frequency, so it is
possible to control several heaters with just one remote.
Control unit overheat. Check installation clearances.
Let heater cool for 15 minutes and restart heater.
Lamp is damaged.
Arrange for replacement lamp with your Herschel Dealer.
ENGLISH
Publicidad
Tabla de contenido
