Defort DRH-500N-K Instrucciones De Servicio página 2

5.1
1
2
5.2
1
2
6
2
1
2
1
7 10
8
9
a sudden, dangerous reaction), immediately switch off the
English
tool
Be aware of the forces that occur as a result of jamming
(especially when drilling metals); always hold the tool
Rotary hammer
Þ rmly with both hands and take a secure stance
Always disconnect plug from power source before mak-
INTENDED USE
ing any adjustment or changing any accessory
This tool is intended for hammer drilling in concrete, brick
Holding the tool
and stone; for drilling in wood, metal and plastic as well as
- keep the ventilation slots uncovered
for screwdriving (speciÞ c accessories should be used) - do not apply too much pressure on the tool; let the tool
The hammering system in this tool outperforms any tradi- do the work for you
tional ratcheting drill when drilling in concrete
This tool is designed for use in combination with all stand-
Your machine is double insulated in accord-
ard SDS+ accessories ance with EN 50144; therefore no earthwire
is required
1
TECHNICAL SPECIFICATIONS MAINTENANCE
PRODUCT ELEMENTS 2
Make sure that the machine is not live when
carrying out maintenance work on the motor.
1 On/Off switch
2 Switch locking button
3 Switch for selecting operating mode Regularly clean the machine housing with a soft cloth,
4 Locking sleeve preferably after each use. Keep the ventilation slots free
5 Auxiliary handle from dust and dirt.If the dirt does not come off use a soft
cloth moistened with soapy water. Never use solvents
SAFETY such as petrol, alcohol, ammonia water, etc. These sol-
WARNING! Read all instructions. Failure to follow all in- vents may damage the plastic parts.
structions listed below may result in electric shock, Þ re Every six months it is recommended to take your machine
to Service Center to change the grease.
and/or serious injury.
Should a fault occur, e.g. after wear of a part, please con-
Wear ear protectors with hammer drills (exposure to tact your local SBM Group dealer.
noise can cause hearing loss)
ENVIRONMENT
Use auxiliary handles supplied with the tool (loss of con-
trol can cause personal injury) In order to prevent the machine from damage during
Avoid damage that can be caused by screws, nails and transport, it is delivered in a sturdy packaging. Most of the
other elements in your workpiece; remove them before packaging materials can be recycled. Take these materi-
you start working als to the appropriate recycling locations. Take your un-
Always keep the cord away from moving parts of the wanted machines to your local SBM Group dealer. Here
tool they will be disposed of in an environmentally safe way.
When you put away the tool, switch off the motor and
ensure that all moving parts have come to a complete
standstill
Use completely unrolled and safe extension cords with
a capacity of 16 Amps (UK 13 Amps)
In case of electrical or mechanical malfunction, immedi-
ately switch off the tool and disconnect the plug
SBM Group can assure ß awless functioning of the tool
only when original accessories are used
Use only accessories with an allowable speed matching
at least the highest no-load speed of the tool
This tool should not be used by people under the age
of 16 years
Be careful not to drill or drive into areas where electrical
wires may be contacted
If the cord is damaged or cut through while working, do
not touch the cord, but immediately disconnect the plug
Never use tool when cord is damaged; have it replaced
by a qualiÞ ed person
Always check that the supply voltage is the same as
the voltage indicated on the nameplate of the tool (tools
with a rating of 230V or 240V can also be connected to a
220V supply)
If the drill bit becomes unexpectedly jammed (causing
6