Safety Precautions
1. CAUTION! This equipment should be inspected
frequently and collected dirt removed from it
regularly to prevent excessive accumulation that
may result in flashover or a risk of fire.
2. WARNING! RISK OF ELECTRIC SHOCK – These
servicing instructions are for use by qualified
personnel only. To reduce the risk of electric shock,
do not perform any servicing other than that
contained in the operating instructions unless you
are qualified to do so.
3. To reduce the risk of electric shock, this equipment
has a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact
qualified personnel to install the proper outlet.
Do not alter the plug in any way.
4. This product complies with the maximum allowable
concentration of ozone of 0.050 parts per million by
volume (ppmv) in a 24-hour period. The Health
Canada Guideline 2010 recommends that the
maximum exposure limit, based on an averaging
time of 8 hours, is 0.020 ppmv or less when tested
in a sealed, controlled room approximately 30 m
5. This device complies with Part 15 of the FCC Rules /
Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
6. Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
7. This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses and
can radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to
try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
www.electrolux.com
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
8. To satisfy FCC / IC RF exposure requirements, a
separation distance of 20 cm or more should be
maintained between the antenna of this device
and persons during device operation. To ensure
compliance, operations at closer than this
distance is not recommended.
ENGLISH
Thank you for choosing the Electrolux air purifier
Pure A9.
Always use original accessories and spare parts to
get the best results. This product is designed with the
environment in mind. All plastic parts are marked for
recycling purposes.
BEFORE STARTING
Read this manual carefully.
at all parts described are included.
3
.
Pay special attention to the safety precautions!
Picture pages 4-5
BEFORE FIRST USE
Place the product according to the instructions
below for optimal operation and results:
1
Operate the air cleaner in an enclosed area.
Close all doors, windows, and other openings
connecting to the outside of the room.
2
Place the air cleaner in a location that does
not restrict the airflow through the top of the
appliance.
3
The appliance must be placed on a leveled floor
that can support it.
4
There should be a minimum of 30 cm of clearance
around the appliance.
Remove the plastic protective bag from the
HEPA Filter:
5
Pull the Fabric handle outward to remove the air
intake door.
6
Take out the HEPA Filter pulling it out by the
handle.
7
Remove the plastic protective bag from the HEPA
Filter
8
Reinstall the HEPA Filter into the appliance.
7