Fm Mode; Audio Setting - i-box Barrel Manual

Factory Reset:
delete any presets or alarm settings.
System
<Factory Reset >
SW version:
Software version.
System
<SW version >

FM Mode

Press the Power / Mode button (4) to enter FM radio mode.
Scan setting:
By default the FM scan stores all available stations even if
the signal is weak and the audio quality poor. To store just the stations with
a strong signal, follow the steps below.
FM
<Scan setting >

Audio setting:

By default all stereo stations are reproduced in stereo. For
weak signals, this may result in poor quality audio. The audio quality can be
improved by using the mono only setting. Follow the steps below.
FM
<Audio setting >
Preset FM Mode
To save and recall a preset station while in FM Radio mode, follow the same
steps found in the DAB preset section on page 8.
System:
FM system settings): Same as the DAB mode system settings.
(
Barrel | 13
Resets your Barrel to factory default settings. This will
Factory Reset
<No> Yes
SW version
<dab-ser-c912C-
Scan setting
<All stations
Audio setting*
<Stereo allowed
Factory Reset
No <Yes>
* Scan setting
> <Strong station
Audio setting
> <Forced mono
>
>