osann BOOBOO Jazzi Manual página 19

10) Adjusting the push handle height
Press the button (A) on the push handle, pull or
push the push handle to the desired height and
release the button. Check that the push handle is
fully engaged in the desired position.
11) Adjust the backrest
Pull the lever at the top of the backrest and adjust to
the desired position. Check that the backrest is fully
engaged in the desired position.
12) Adjust the leg support
Press button (A) on both sides of the leg support
and adjust it to the desired position. Check that the
leg support is fully engaged in the desired position.
13) Fold the pushchair with sports buggy
attachment, forward facing
Note: Always apply the parking brake before folding.
First bring the push handle to the lowest height set-
ting (A). Fold the leg support completely upwards.
Push the safety button on the folding lever (B) under-
neath the sports buggy attachment to the left, pull
the lever upwards and lift the pushchair at the same
time. It can now be folded.
14) Folding the pushchair with pushchair
attachment, rear facing
Hint: Always apply the parking brake before folding.
First bring the push handle to the lowest height set-
ting (A). Use the backrest adjustment lever (B) and
push the backrest towards the push handle. Push the
safety button on the folding lever (C) to the left, pull
the lever upwards and lift the pushchair at the same
time. It can now be folded.
- 19 -
15) Use with carrycot
First put the carrycot adapters onto the frame and
make sure they are fully engaged. Then put the
carrycot on the adapters attached to the frame and
make sure that the carrycot is fully engaged.
To detach the carrycot from the frame, press the
button (2) on both sides of the frame as shown in the
graphic on the right and lift the carrycot out. To de-
tach the carrycot adapters from the frame, press the
button (1) and pull the adapter off the frame. Repeat
the process on the other side.
Attention: It is not possible to fold the frame with the
carrycot. Remove the carrycot and the carrycot ad-
apters before folding.
Note: Always apply the parking brake before folding.
16) Use with baby seat (optional)
First put the baby seat adapters onto the frame (1)
and make sure that they are fully engaged. Then pla-
ce the baby seat (2) on the adapters attached to the
frame and again make sure that the baby seat is fully
engaged. The baby seat is not included. Please also
refer to the baby seat instruction manual for how to
install and remove with a pushchair and adapters.
Never use the baby seat with the adapters when
facing forwards! The baby seat must always be
mounted so that they are facing the push handle.
To detach the baby seat adapters from the frame,
press the button (3) on both sides of the frame as
shown in the graphic on the right and pull the adapter
off the frame. Repeat the process on the other side.
Attention: It is not possible to fold the frame with
the baby seat. Remove the baby seat and adapter
before folding.
EN