Lenco SB-022 Manual Del Usuario página 4

COMPONENTS & FUNCTION
PLS KINDLY CHECK THE FUNCTION INDICATOR
BEFORE USE THE SPEAKER SYSTEM
FRONT PANEL
5
7 9
8
6
REAR PANEL
10
POWER ON/OFF VOLUME
LED INDICATOR
PLAY/PAUSE/CALL
7
3.5MM AUX INPUT
9
DC5V POWER
4
All manuals and user guides at all-guides.com
SIDE
VOLUME +/-
BACKWARD
6
NEXT
8
TF CARD
10
CHARGE INDICATION
HOW TO USE THE SB-022
1.BLUETOOTH MODE
1.1. Bluetooth version: Bluetooth 3.0 specifications, support HSP, HFP, A2DP, AVRCP
format, English language notification, Bluetooth pairing name: Lenco SB-022
1.2. Rotate the volume knob to turn on the machine, then blue color Bluetooth LED
indicator blinking, with notification of melody.
1.3. BLUETOOTH LED light flash by 100ms speed, use your mobile phone sourcing "Lenco
SB-022" name, then connect and pairing it. If need password, then type"0000". After
connected, the blue LED indicator light on and notification one beep. Then play
music by bluetooh mode, the blue LED indicator light flash slowly by a 1000ms
speed. When smartphone paired this machine again, it will connect automatically.
1.4. When play music by Bluetooth mode, there is phone call, speaker will stop play
music and enter into voice call mode automatically.
1.5. When you disconnect the Bluetooth, there is notification sound indicate
"DISCONNECT", and the speaker will enter into detective mode.
1.6. Rotate the volume knob to make the volume up and down.
2. LINE IN MODE
2.1. Connect the speaker by stereo cable, speaker will enter into Line in mode, and
notification sound "LINE IN". Then use your smartphone or other connected device
to play music.
2.2. AUX IN mode, red LED blinking.
2.3. Disconnected the stereo cable, speaker enter Bluetooth mode automatically.
2.4. Rotate the volume knob to make the volume up and down.
3. TF CARD MODE
3.1.Turn on the speaker, speaker enter Bluetooth mode automatically, then insert TF card,
speaker will enter TF card play mode. But before Turn on the speaker, insert the TF
card,then power on, speaker will enter into: CARD mode
3.2.When play the music, red LED light on and flash slowly by 1000ms speed, when pause
the speaker, LED light will stop flash, just keep on.
4. REMARK
The maximum sample rate of MP3 track is 44.1KHz.
5. CHARGING
5.1. Use the micro USB to USB power cable to connect speaker and PC or 5V adaptor,
then start charge, the charge indicator Light on.
5.2. When charge full, the charge indicator light turn off.
6. LOW POWER PROTECTION
5