Cleaning And Maintenance - Beurer Barbers Corner HR 2000 Instrucciones De Uso

Eyebrow trimming
You can trim your eyebrows to 3 mm or 6 mm with
the comb attachment provided.
1. Take the protective cap off the miniature blade.
2. The comb attachment is labelled with 3 mm on
one side and 6 mm on the other. Place the comb
attachment onto the miniature blade from above.
Make sure that you have placed the correct side
of the comb attachment (3 or 6 mm) on the
miniature blade. Ensure that you hear and feel
the comb attachment click into place.
3. Slide the ON/OFF switch
device.
4. Run the comb attachment over your eyebrow
from the outside of the brow inwards towards
your nose.
5. When you are finished with the application, slide
the ON/OFF switch
device.
6. Pull the comb attachment up and off.
7. Place the protective cap onto the miniature blade.

8. Cleaning and maintenance

Cleaning the miniature blade
Blow on the miniature blade after the application
in order to clean it of hair. Fine hairs can also be
removed with your fingers.
WARNING
When cleaning with your fingers, make sure that
you do not injure yourself on the sharp edges of the
miniature blade.
To clean the miniature blade particularly thoroughly,
you can rinse it under running water. Proceed as
follows:
up to switch on the
down to switch off the
19