Usage - Beurer Barbers corner HR 6000 Instrucciones De Uso

Mains operation
To operate the device with the supplied mains adapter, proceed as follows:
1. Connect the mains adapter to a suitable socket.
2. Plug the other end of the mains adapter into the connection socket on the un-
derside of the device. The battery indicator shows you the current battery state
in percent and the charge indicator begins to flash. The mains adapter supplies
enough energy to charge the battery and operate the device at the same time.
3. After use, pull the mains adapter from the socket and the device.
WARNING
Never use the device in the shower when it is being operated via the mains.
The hand-held part of the Body groomer must be disconnected from the con-
nection cable before use in a damp environment.

8. Usage

Travel lock
The device has a travel lock. If the travel lock is activated, it is not possible to
switch on the device. The travel lock prevents the device from switching on by
accident (e.g. when transporting it in a suitcase). To activate the travel lock,
press and hold the ON/OFF switch for 3 seconds. The travel lock indicator be-
gins to flash. The device is now locked. If the ON/OFF switch is briefly pressed
when the device is locked, the travel lock indicator will light up in the display to
indicate that the device is locked. To deactivate the travel lock, press and hold
the ON/OFF switch again for 3 seconds.
Direct drive function
If the battery is completely flat, you can continue using the device immediately
via mains operation.
Tips before cutting/trimming hair
• Be particularly careful when using the device in areas with thin skin or skin
creases (e.g. armpits or pubic area) in order to avoid injuries. Try to stretch
the skin using your fingers.
Cutting/trimming hair
You can either trim body hair with the length-adjustable comb attachment or
remove it entirely without the length-adjustable comb attachment.
• If you want to use the length-adjustable comb attachment, attach it to the
device as shown.
Here, slide the front part of the length-adjustable comb attachment onto the
stainless steel razor blade and press the tabs on the back of the length-adjust-
able comb attachment onto the device until you can hear and feel it click into
place. When selecting the trimming length with the length-adjustable comb
22