Bosch Sensixx x DA70 Instrucciones De Uso página 19

The iron does not
heat up.
2. The "SensorSecure" system has been
The "TempOK"
lights inside the
temperature
The clothes tend 1. The temperature is too high.
to stick
Water drips out of
together with
steam.
3. You have pressed the shot of steam
Steam does not
come out.
2. The temperature is too low. Anti-drip
Smoke comes out 1. This may be caused by the lubrication
when connecting
time.
Excessive dripping 1. No proper closing of "Calc'nClean"
or steaming.
Deposits come out 1. Traces of lime scale are coming out of
through the holes
in the soleplate
If none of the above solves the problem, get in touch with an authorised technical service.
* Model dependent
minimum.
activated. The iron is set to stand-by.
cooling down to the selected
temperature.
low.
for 5 seconds between each press.
position.
system is activated.
of some of the internal parts.
system.
the steam chamber.
1. Turn to a higher position.
2. Grip the handle of the iron to re-start
it.
1. This is normal and lights will stop
temperature is reached.
down and wait until the iron has
cooled down.
higher setting and wait until the
"TempOK" lights inside the
remain lit continuously.
setting.
3. Wait 5 seconds between each press
of the shot of steam button.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if
compatible with the fabric.
1. This is normal and will stop after a
few minutes.
1. Actuate a few times the "clean"
1. Carry out a cleaning cycle
19
B O S C H