Dualit Cafe Plus Manual De Instrucciones página 5

PROGRAMMABLE DOSING MEMORY
The Capsule Machine has an Auto-Dose feature that ensures the correct amount of drink is
dispensed every time. Ensure the machine has enough water in the Water Tank and is switched on.
NOTE - The factory setting of the machine is programmed to 35ml for the Espresso button, 70ml
for the Lungo button and 180ml for the Tea button. However, this can be adjusted to suit your taste
preference.
For tea, we recommend using 1 capsule for a 150-180ml tea cup (depending on your strength
and taste preference). For a mug (250ml) we recommend using 2 capsules and setting your dose to
125ml.
4.A 4.B
Open the Lever fully and insert Press the Coffee Button once
a capsule. Then push the Lever and hold for 5 seconds, then
down fully. Place a cup on the release. The machine will start
Drip Tray. dispensing. Press the Coffee
Button again when the desired
amount is reached, and the
dispensing will stop.
4.D 4.E
Press the Tea Button once The Dosing Memory has now
and hold for 5 seconds, then been programmed to dispense
release. The machine will start your chosen quantity of coffee or
dispensing. Press Tea Button tea. NOTE: program will be saved
again when the desired amount even if machine is unplugged.
is reached and the dispensing
will stop.
4.C
Press the Coffee Button twice and
hold for 5 seconds, then release.
The machine will start dispensing.
Press the Coffee Button again when
the desired amount is reached, and
the dispensing will stop.
12
AUTO-START
The Auto-Start feature allows you to pre-select your dose whilst the machine is
warming up. Then, once the machine has warmed up it will automatically dispense
the selected Coffee or Tea.
5.A 5.B
Lift the Lever fully and insert Place a small cup on the Drip
the capsule. Then close the Tray. If you like a particularly hot
Lever fully. The Coffee & coffee, we recommend
Tea Button will be flashing to pre-warming the cup first.
indicate that the machine is
warming up when the machine
is turned on.
5.D 5.E
The machine will now auto After using the machine we
dispense the selected beverage, recommend flushing the
once it has warmed up. machine through. Remove
capsule and ensure the Lever is
pushed down fully, then press
the Coffee Button. Water will
flush through the machine and
into the Drip Tray. Empty the
Drip Tray, switch off and
unplug after use.
DESCALE
HARD WATER WILL CAUSE LIMESCALE BUILD-UP, RESULTING IN BLOCKAGES THAT
CAUSE PERMANENT DAMAGE.
IMPORTANT NOTICE: PRODUCT FAILURE DUE TO THE BUILD-UP OF
LIMESCALE IS NOT COVERED BY GUARANTEE.
Dualit recommends cleaning and descaling regularly, in a well-ventilated area to prevent limescale
build up in the machine. Please note: Always clean your machine before beginning
the descaling process. Refer to the cleaning section. Refer to the Limescale Warning to
determine descaling frequency. It is essential that a compatible descaler is used. Dualit recommends
using Kilrock's coffee compatible descaler. The descale process takes approximately 30 minutes.
Caution: Avoid contact with descaling solution. Steam released during descale
process may be harmful. Risk of scalding and injury.
5.C
Whilst the machine is warming
up, press the Coffee Button
once for Espresso, twice for
Lungo or press the Tea Button
once for tea. The selected
Button will flash and the other
Buttons will cease to illuminate.
Tip: press Buttons firmly.
13