Technical Specifications - Perel Tools EFANF40 Manual

5. Assembly
• Take the two-part stand and form the X-shaped base (17).
• Place the lower pipe (15) with the pipe support onto the X-shaped base (17) and fix it with the four included
screws.
• Loosen and remove the height adjuster (14) from the lower pipe (15). Slide the plastic base ornament (16) over
the lower pipe (15) onto the base (17). Extend the upper pipe (13) and slide the height adjuster (14) over the
upper pipe (13) onto the lower pipe (15). Tighten.
• Attach the motor (10) with switch compartment (12) onto the upper pipe (13). Ensure the switch compartment (12)
is pushed fully onto the upper pipe (13). Secure with the provided screw.
• Loosen the guard mounting nut (5) from the motor housing (7).
• Position the rear guard (6) firmly against the motor housing (7) and fasten tightly by turning the guard mounting
nut (5) in a clockwise direction.
• Push the blade (4) along the shaft. Fasten it firmly by turning the spinner (3) in an anticlockwise direction.
• Place the front guard (2) against the rear guard (6). Fix it with the provided clips.
6. Oscillation Control
Push the oscillation knob (9) to activate or deactivate the oscillation.

7. Technical Specifications

Power Supply
Power
Dimensions Fan
Oscillation Arc
Weight
Max. Ambient Temperature
Box Dimensions
The information in this manual is subject to change without prior notice.
EFANF40
max. 230VAC / 50Hz
50W
Ø 40cm
87°
5kg
50°C
558 x 470 x 128mm
2 PEREL