Foppapedretti TEDDYTOUR Instrucciones Para El Montaje página 11

• ENGLISH •
All manuals and user guides at all-guides.com
ASSEMBLY
OPENING
1. Remove the cot from the carry bag and undo the Velcro fasteners at the side of the base.
2. Open out the frame by extending the legs.
3. First pull up the hinge locks on the short sides until they snap into place and then repeat with the ones
on the long sides. Make sure the hinges are locked into place. The long and short sides must not bend
when they are pressed down.
3. NOTE: to facilitate fastening of the side joints, make sure the bottom of the cot has been raised.
4. Press the central part of the cot down, a click will indicate that it has been successfully locked into
place.
IMPORTANT: the base of the cot must not be pushed down until the rails are locked into place, as the
base forms the safety lock. The arms will not lock into place when the safety lock is engaged; in that case,
you will need to pull up the base and lock the arms again.
5. The open cot.
6. Place the mattress on the bottom of the cot, insert the strips through the slots, present on the base,
and attach the Velcro to the underside of the base to fix the mattress in place.
NOTE: Before using the cot, make sure that the 4 sides are correctly fastened and that the bottom is in
the horizontal position.
CLOSING
1. First remove the mattress and lift the central part of the cot as high as possible by pulling the strap (A)
raise the central part to about 10 cm below the lateral sides.
2. Press button (A) on each side to release the locking device, positioned at the middle of the side and
keeping it pressed, gently lift the side to release the locking device. While still holding the button (A),
fold the side toward the base.
3. Fold the cot and wrap the mattress around it. Secure with the Velcro fasteners.
4. Place the cot in the bag.
11