EN
User Manual
Tower fan
1
Safety instructions
The user manual is part of the product and contains important information for correct use.
•
Read the user manual completely and carefully before use.
The user manual must be available for uncertainties and passing the product.
•
Keep this user manual.
Risk of electric shock
When the product comes into contact with water, this may cause an electric shock.
•
Do not use the product with wet hands.
•
Do not use the product in the immediate vicinity of water, such as bathtubs, washbasins or pools.
Rain splashing on the product may cause an electric shock.
•
Do not place the product near an open window.
Voltage-free only with pulled plug.
•
In case of emergency, after use and during a thunderstorm, pull the mains plug out of the socket di-
rectly at the plug housing.
•
Do not open the housing.
•
Do not modify product and accessories.
•
Do not short-circuit connectors and circuits.
•
Check regularly that the appliance cable is still intact.
•
Do not use the product if the cable is damaged.
A defective device may not be put into operation, but must be disconnected from mains and protected
against further use.
•
Use product, product parts and accessories only in perfect condition.
•
In case of questions, defects, mechanical damage, trouble and other problems, non-recoverable by
the documentation, contact your dealer or producer.
•
Do not repair defective products yourself, but contact the dealer or the manufacturer.
Risk of entry
Rotating parts can pull loose clothing and hair. This may result in injuries or damage to the device.
•
Keep hair and loose clothing away from rotating parts.
•
Make sure that the fan is not near curtains or other objects that could be pulled into the fan.
Risk of injury by moving product parts
There are moving parts behind the blade guard of the fan.
•
Do not insert your finger or other objects through the blade guard.
This may result in injuries or damage to the device.
•
Only operate the device if the blade guard is closed and in good order.
•
Do not use the device if the blade guard is damaged.
•
Switch the device off and unplug the power cord before removing the blade guard.
•
Always pull the product by the plug, not the cable.
Tripping hazard
•
Mind placing cables in a way that nobody will be disabled and the cable not be damaged.
Operation and storage conditions
•
NEVER leave the product unattended while in operation.
•
Do not cover the product.
•
Keep fan slots and vents free.
•
Do not operate the product in dusty environments or in areas with inadequate ventilation.
•
Do not operate the fan in the vicinity of explosive and/or flammable gases.
•
Do not place or operate the product near open flames, cooking appliances or devices that generate
heat such as radiators or stoves.
•
Place the product on a stable, level, dry and dust-free surface so that it cannot tip over during opera-
tion and the surface cannot be damaged by vibrations.
•
Make sure that the product stands securely.
The fan must not stand on the mains cable so that it does not tip over during operation.
•
Avoid stresses such as heat and cold, moisture and direct sunlight, microwaves, vibrations and me-
chanical pressure.
•
Switch off the device and disconnect it from the mains when not in use, for cleaning or in the event
of a malfunction.
Not recommended for children and people with physical and/or mentally limited capabilities.
•
Secure the product against accidental use.
•
Secure packaging, small parts and insulation against accidental use.
Battery hazards
The remote control is equipped with a lithium button cell. It can be replaced.
•
Keep batteries out of the reach of children.
If swallowed, there is a risk of severe internal burns or even death. Seek immediate medical attention if you
believe someone may have swallowed or otherwise ingested the battery.
•
Never use batteries when they are dented, leaked or damaged.
•
Remove leaked, deformed or corroded batteries from the product and dispose them by appropria-
te protectives.
If a battery has leaked, avoid contact with skin, eyes and mucous membranes. If necessary, rinse affected
areas with water and seak medical attention immediately.
•
Do not deform, burn or disassemble batteries and never puncture them with a sharp object.
Extreme heat can lead to explosion and/or leakage of corrosive liquid. Mechanical damage can cause gas-
eous substances to escape, which can be highly irritating, flammable or toxic.
•
Do not short-circuit batteries or immerse them in liquids.
There is a risk of explosion, fire, heat, smoke and/or gas development.
•
If the battery is accidentally dropped into water, remove it immediately. Place the battery in a safe,
open area and stay away until it is completely dry. Do not reuse the dried battery, but dispose of it as
indicated in chapter 10.2.
2
Description and function
2.1
Product
The product is an oscillating, quiet tower fan with power cable.
○ 3 power levels: LOW, MED, HIGH
○ integrated timer function up to 7.5 hours
○ 3 modes: Standard, NATURAL and SLEEP
2.2
Scope of delivery
Fan body, right base, left base, 3 Phillips screws (L 14 mm x Ø 4 mm), remote control,
1x lithium button cell (CR2025), User Manual
REV2021-11-04
V2.0aw
Subject to change without notice.
2.3
Specifications
Article number
Input
Rated power [W]
Fan power input (P) [W]
Standby power consumption (P
) [W]
SB
Max. fan flow rate (F) [m³/min]
Service value (SV) [(m³/min)/W]
Measurement standard for service value
Max. air velocity (c) [m/s]
Fan sound power level (L
) [dB
]
WA
A
Protection level / Protection class
Colour
Device connection
Cable length (incl. plug) [m]
Dimensions
W x H x D [cm]
Ø [cm]
Weight [g]
Type
Input voltage
Dimensions [mm]
Weight [g]
Type
Nominal voltage, Capacity
Weight [g]
2.4
Operating elements and product parts
3
Intended use
We do not permit using the device in other ways like described in chapter "Description and
Function" or in the "Safety Instructions". Use the product only in dry interior rooms. Not attending
to these regulations and safety instructions might cause fatal accidents, injuries, and damages
to persons and property.
IPX0: This product is not protected against water.
4
Preparation
1. Check the scope of delivery for completeness and integrity.
2. Compare the technical data of the product and the power supply. These must be identical.
5
Assembly
1. Connect the left base (6) to the right base (7) and make sure that the connection is tight.
2. Place the fan body (3) on the assembled base.
3. Feed the mains cable (4) through the centre of the assembled base.
4. Fix the fan body to the base using the 3 screws.
- 3 -
52718, 59517
52718
220-240 V
, 50 Hz
50
46.7
0.41
4.3
0.09
EN ISO 5801:2017, EN 50564:2011
3.0
59.0
IPX0 / II
black
Euro plug (type C, CEE 7/16)
1.6
11.7 x 76.5 x 14
22.1
2550
Remote control
Infrared
3.0 V
86.3 x 40 x 7
10
Battery
Lithium button cell (CR2025)
3.0 V
, 150-165 mAh
2.5
1 Function keys
2 Status indicators
3 Fan body
4 Mains cable
5 Remote control
6 Left base
7 Right base
8 Battery compartment
by Wentronic GmbH | Pillmanstraße 12
38112 Braunschweig | Germany
59517
grey
Goobay®