BOCCHI LAVITA 1168 Serie Instrucciones De Instalación página 3

Sink Installation
• Unpack the sink and inspect for defects. If you have any questions, contact BOCCHI immediately toll-free at
877-565-2221 or email BOCCHI directly at info@bocchiusa.com
• Locate the bolt holes on the sink.
• With the help of another person, carefully put the sink into place
on the wall with the legs set into place. While holding the sink in
place, have someone mark BOTH the bolt holes on the wall, and
around the foot of each leg.
• Carefully set the legs and sink back down.
• Make sure that there is proper backing in the wall to carry
the weight of the sink.
NOTE: 1168 sinks weigh approximately 61 pounds. To properly
secure the sink into place, safely, the weight should be
supported by the wall and NOT carried by the legs of the sink.
• Use the drill and coordinating drill-bit type and size
for the wall material , to drill the bolt holes.
• Install the bolt(s) delivered with the sink. If drilling
directly into wood, do not use the supplied anchors.
• Hang the sink onto the bolts and slide the plastic spacer and
washer over the bolt(s), followed by the metal washer and nut.
1st Plastic spacer
• Level the sink and use the adjustable wrench, or a standard 13mm
wrench, to slightly tighten the nut onto the bolts. Leave a bit of flex.
CAUTION: DO NOT overtighten! The nut should NOT be tightened all
the way. It will need a little bit of flex to be able to get the legs into
place . You will finish tightening them after legs are set.
www.BOCCHIUSA.com
2nd Metal Washer 3rd Nut
3