Frequently Asked Questions (Faq's) - Life Smart LS1002THD13 Manual Del Usuario

FREQUENTLY ASKED QUESTIONS (FAQ'S)

My heater emits a "strange" odor when I first open the box/when I turn the heater on for the
first time. Why?
These are both normal. This heater is treated with a special heat safe/resistant coating. This
odor will sometimes be present when the box is opened, and may be compared to a heaters
version of "new car smell." Also, similar to all hearth appliances (woodstoves, etc.), the coating,
exposed to heat, will produce this particular odor during the first few hours of operation. This will
dissipate after the break-in period. If you are sensitive to odors, you may want to pre-burn the
unit in a garage with the door open until the initial odor dissipates.
If my heater runs on approximately 1500 watts, how many BTU's is that? Is that a lot of heat?
At 1500 Watts, your heater will use approximately 5100 BTUs. 5100 BTUs, compared to your
home furnace, is a very small amount of heat. It may take several minutes, to several hours to
heat your area, depending on various factors (see Heater Placement).
Can my heater really operate on less money per day? What are my operating costs?
Most Definitely. If the heater is used as it is intended (as supplement/assist heat), it should cycle
on and off, allowing for it to heat a total of approximately 8 out of the 24 hours of the day. Using
the national average of approximately 10¢ per kWh (look at your bill for exact cost per kWh--will
vary per state), your average heating cost (add a few cents just for having it plugged in) should be
less per day compared to your main furnace. The costs will increase if it is used as the single
source of heat, or if heat somehow escapes the room being heated, since the "on" cycle will run
longer.
The Formula: To determine the cost of this or ANY 1500 watt appliance, multiply 1.5 X your cost
per Kilowatt Hour. You can find the cost per KWH for your state at:
http://www.eia.doe.gov/fuelelectric.html
Can the heating elements be replaced?
If after speaking to a Lifesmart Technical Support Agent, it is determined that heating elements
have failed. Heating elements may be replaced by obtaining them from the Manufacturer. All parts
may be purchased through LIFESMART PRODUCTS if your product is out of warranty. Note: If
you feel that the elements are definitely faulty right out of the box, contact the LIFESMART
PRODUCTS Technical Support department first (for troubleshooting and verification).A
representative can then direct you on to the next step.
Once I plug the unit in and turn it on, how long will it take to heat my room?
Typically it takes about ½ hour to feel a temperature change. Please remember that with any type
of heating process, there are many variables: Location (in the home), floor plan and size of the
room, how well the room is insulated, how many doors/windows, how much bare concrete (acts
as a heat sink with any type of heating), the opening and closing of an exterior door, long
hallways, high ceilings, etc. Customers with smaller rooms experience quick heat changes.
Others with larger and open floor plans can expect up to 24 hours to heat up.
I don't have a grounded outlet; can I use adapters, a 2-prong power strip, or remove the ground
prong from the cord?
Definitely NOT! If you don't have a grounded outlet, contact a certified electrician for advice.
Removing or altering any part of the heater's original design or intent (including the power cord)
will not only void the warranty, but will make you liable for any unexpected or hazardous results.
6