Probuilder 43660 Manual De Instrucciones página 71

12 Use extension cords for outdoor use
– Only use extension cords approved for
outdoor use and marked accordingly.
– When using the cable drum, unroll it
completely before use.
13 Always be attentive
– Be careful with what you do. Use
common sense when going about
your work. Do not use the power tool
when you lack concentration or are
distracted.
14 Examine the power tool for possible
damage
– Before using the power tool further,
carefully check protective devices or
slightly damaged parts to ensure that
they are in a proper working condition
as intended.
– Verify that the moving parts are
functioning properly and do not
bind, and that no parts are damaged.
All parts must be mounted correctly
and must meet all of the conditions
necessary for ensuring proper
operation of the power tool.
– Damaged protective devices and
parts must be repaired or replaced as
intended by an approved specialist
workshop, unless otherwise speci� ed
in the Instruction Manual.
– Damaged switches must be replaced
by an authorized service workshop.
– Do not use faulty or damaged
connection cords.
– Do not use power tools on which the
switch cannot be turned ON and/or
OFF.
15 Only authorized electricians should be
assigned to repair your power tool
– This power tool complies with the
relevant safety regulations. Repairs
shall only be carried out by an
authorized electrician using original
spare parts; otherwise the user may
suff er accidents.
16 Warning!
– For your own safety, use only
accessories and attachments
speci� ed in the instruction manual
or recommended or speci� ed by the
manufacturer.
The use of application tools or
accessories other than those
recommended in the instruction
manual or in the catalog may pose a
personal injury hazard to you.
17 Noise
– When using the compressor, wear ear
protection.
18 Replacing the connection cord
– If the connection cord is damaged, it
must be replaced by the manufacturer
or a quali� ed electrician in order to
avoid hazards. Risk of electric shock
19 In� ating tires
– Check the tire pressure immediately
after � lling using a suitable pressure
gauge, e.g. at a service station.
20 Road-mobile compressors in
construction site operation
– Make sure that all hoses and � ttings
are suitable for the highest permissible
working pressure of the compressor.
21 Installation site
– The compressor must always be set up
on a level surface.
GB
71