Helo HNS-M Instalación Y Manual De Uso página 41

Instructions for Use and Installation HNS-M / HLS
Installing control panel, push button and thermostat
The control panel is filled with sealant,
therefore is moisture resistant.The control
panel may be installed directly on a wall.
Pipe hole in the steam room should be
sealed, so that moisture does not travel
along the pipe. This way the cable is hidden
behind the control panel. Alternatively the
cable can come out of the bottom of the
control panel, from a pre-marked hole.
Control panel frame is pressed directly on it.
Detaching is done with tool that comes with
the unit. The frame has small holes on the
edges. (4 holes) Push the locking pin lightly
with the tool through the hole, one at the
time and pull the frame outwards at the
same time.
The push button is filled with sealant,
therefore it may be installed in the steam
room. The push button may be installed
through a wall (acrylic walls) or by making a
suitable hole, where the push button can be
embedded and sealed with appropriate
sealant. Surface installation boxes may also
be used, if necessary, they do not need to be
tight, because the actual push button is
moisture resistant.
The thermostat is installed at 170cm height
from the floor, preferably on the wall opposite
the door. Retaining nut may be used, if
necessary on plexiglass walls. On thicker
walls, you can make a hole and seal it with
appropriate sealant to prevent moisture from
entering the structures. The thermostat is
pushed into the cover, which is then tightened
with a clamping screw.
All manuals and user guides at all-guides.com
Mounting hole Ø 5mm
Locking
Hole
spacing
150 mm
Locking
Led indicator light
ON – OFF button
Retaining nut
Clamping screw
21 mm
Thermostat
55 mm
Locking
180 mm
OK
Locking
ON OFF
40 mm
32 mm
46 mm
24 mm
Wall
24 mm
32 mm
Thermostat
cover
Retaining nut
11