Receiver Controls - Audio-Technica 1800 Serie Instalación Y Manejo

6
E
N
All manuals and user guides at all-guides.com
ATW-R1810 Single-channel Receiver Controls
1
LCD Liquid Crystal Display shows battery status and frequency settings.
2
Antenna Input Jacks BNC-type antenna connectors. Attach the antennas to the antenna input jacks. Make certain that
during operation there is a clear open-air path between the receiver antennas and the
transmitter.
3
Diversity Indicators True Diversity operation: two antennas feed two completely independent RF sections on the
same frequency; automatic logic circuitry selects the superior signal.
Diversity Indicators A and B show which tuner has the better reception and is in operation.
4
Power / Set Button Turns the unit on and off. Use with the Up/Down arrows to choose operating frequencies
manually or automatically (using your choice of three automatic scan groups).
5
Power/Peak LED Indicates when the unit is on. Also indicates receiver overload by turning off; too much signal will
cause blinking LED (off during peaks). To correct overload, adjust audio gain on transmitter.
( See Audio Input Level (Gain) Adjustments on your transmitter, page 12. )
6
Up/Down Arrows Press Up or Down arrows, in conjunction with the Power/Set button, to choose operating
frequencies manually or automatically (using your choice of three automatic scan groups).
2
1
3 5
(front panel)
6 2
4