Battery Selection; Battery Installation - Audio-Technica 1800 Serie Instalación Y Manejo

All manuals and user guides at all-guides.com
8
ATW-R1810 Single-channel Receiver Batteries

Battery Selection

Each ATW-R1810 Single-channel Receiver uses four 1.5V AA batteries, not included. Alkaline
type is recommended. Always replace all batteries. Make certain the receiver power is Off
before replacing batteries. Note: The ATW-R1810 receiver also functions without batteries
if connected to an external power supply (12V DC source, 500 mA nominal current,
not included).
E

Battery Installation

1. Open the battery compartment door by pushing the catch back.
2. Observe correct polarity as marked and carefully insert four fresh 1.5V AA alkaline batteries
N
( see above ).
3. Replace the door, making certain the latch clicks securely in place.
Battery Condition Indicator After the batteries are installed, turn the power on. The small red power-on LED ( see a at left )
should light and the LCD window should come on. If this does not happen, the batteries are
b
installed incorrectly or they are depleted.
The receiver's "fuel gauge" battery indicator ( see b at left ) displays a maximum of four bar
segments. When LCD flashes LOW.BAT, the batteries should be replaced immediately to ensure
continued operation.
a