Lovi LS-BE221 Manual página 4

Important! Use pre-boiled/demineralised water, as it prevents lamescale build-up on the heating chamber. The presence
of lamescale on the heating chamber is not subject to complaint. Information on maintaining the proper functioning of the
warmer can be found in the "Descaling" section.
To measure the exact amount of water, use the measuring cup supplied with the warmer. For measuring larger
3.
amount of water use the measuring cup several times. The amount of water is one of the factors that affects the
final temperature of the food, this is why it is very important to measure the water accurately.
There are many factors that have influence on heating time and temperature of the food after heating. The main ones
are: starting temperature of the food, its quantity, type, and consistency, type of material of the container (glass,
plastic) in which the food is heated, and the amount of water used for heating.
The indicated amounts of water are approximate. Due to the above factors, it is not possible to give the exact amount
of water needed for heating. Optimal amounts of water can be easily determined experimentally.
If the food is too hot, then next time add less water to the warmer. If the food is too cold, then the next time add more
water to the warmer.
Place the bottle/jar basket in the warming chamber.
4.
Place the bottle prepared for feeding or an open container in the basket. Place bottle/jar as accurately as possible in
5.
the middle of warmer to ensure even heating.
Note! Make sure that the bottle/container you choose is suitable for boiling according to the manufacturer's instructions.
Put a fitting ring onto to the warmer's body to limit the amount of escaping vapour.
6.
Plug the warmer into the power socket. All icons on the display will appear and then disappear. This means that the
7.
warmer is receiving power.
, and the display will show "00", meaning standby mode. Remember! Never turn on the
Press the ON button
8.
warmer when there is no water in it.
Press the function button
9.
Note! Remember to use the right amount of water. If too much water is added, the food will be heated too long and
its temperature may be too high.
Note! Rapid heating of food frozen in glass bottles and jars is NOT recommended.
Please note that hot vapour is emitted while the warmer is operating. Be especially careful as it can cause severe
10.
burns. Avoid contact with the skin. Keep your face and hands at a safe distance and do not place them above the
warmer while it is in use. To avoid the possibility of burns, never move or carry the warmer while it is working.
After the water evaporates, and the food is heated, the warmer switches off automatically, signalling the end of
11.
the cycle with a „Dee-Dee-Dee" sound. To stop the warmer during the cycle, press the button
warmer, and then disconnect it from the power socket.
Always use a cloth when removing the bottles, containers or jars from the warmer to avoid burns. Note! Do not
12.
touch the body or the heating chamber, because they are hot.
Shake each bottle to mix its contents. Stir food heated in an open container with a spoon. It will ensure an even
13.
temperature distribution.
For the safety of your child, always check the temperature of the food before feeding. Place a small amount of
food on the inner part of your wrist - as the skin is delicate and sensitive at this spot.
For microbiological and hygiene reasons, milk or food that has already been heated and cooled down should
not be reheated. If it have not been used, they should be disposed of.
If you intend to use the warmer again, start the procedure from the first step; if you have finished using the warmer,
14.
disconnect it from the mains.
three times, selecting the „HOT" mode with the
4
icon.
to turn off the