Connecting The Hdbase-T; General; Guidelines For Connection - Samsung BHT Manual Del Usuario

• Updating the OTN
* Admin menu > System > OTN update
You can set to update the firmware automatically or manually.
• Connecting a mobile device
> Mobile Connection
To use Screen Sharing (Smart View), run the Mobile Connection app on your TV.
• Setting the geographical region (Europe only at the first launch)
Region setting is required once after you purchased the TV. Upon completion, your TV is automatically reset
and then you can configure the detailed settings.
– *: The Admin menu can be entered by pressing a combination of VOL > UP > DOWN > ENTER on the remote
control in order.
– Samsung Business TV automatically turns off after no user interaction is detected for 4 hours. To avoid this
issue, you may select the Auto Power Off setting to "Off"
• Settings > General > Eco Solution > Auto Power Off
The recommended daily operation time of this product is less than 16 hours.
(The total usage time is guaranteed up to 30,000 hours. If the product has been used for over 16
hours or its total usage time is over 30,000 hours, the warranty may be voided.)

07 Connecting the HDBase-T

HDBase-T connection of The Terrace for business is built-in for transmission of audio and video data. It does not
support transmission of power, Ethernet and control signals including IR and RS232.

General

• The appearance may differ depending on the product.
• Connecting parts may differ in different products.
• Data transmission is not available if HDBase-T (Rx) is connected to HDBase-T (Tx) through a hub.
• While installing the product, be sure to use the cables and TX devices certified by the HDBase-T Alliance.
• When connecting an external device via HDBase-T, for the maximum resolution, use a certified TX device
that supports 4K 30 Hz.
• This port (HDBT port on the TV) does not support ARC (eARC).

Guidelines for connection

• HDBase-T (Tx) transmits data from an external device to HDBase-T (Rx). Only 1:1 connection is available
between devices. Make sure to connect them via a LAN (CAT6 or higher quality) cable.
• HDBase-T works with unshielded twisted pair (UTP) or shielded twisted pair (STP) cables; but, to ensure
CE compliance, STP cables and STP Connectors are required. STP cable and connectors are recommended
to safeguard against unpredictable environmental electrical noise which may impact performance. It is
recommended to use an STP cable to maximise performance. Using a UTP cable or patch may decrease
performance.
• Before replacing the external device, first remove the HDBT LAN (CAT6 or higher quality) cable.
English - 19