Programming - A.E.B. PUMA Manual Instrucciones De Montaje Y Garantia

Programming

The PUMA Timing Advance Processor can be reprogrammed,
therefore only one Timing Advance Processor model can be adapted
to different car models, simply updating the software inside it by
means of the AEB011 PROGRAMMING KIT that has been used
until now to reprogram the OBD2 Emulators and 511N.
The PUMA Timing Advance Processor replaces the following models:
AEB524 Black, AEB527 Dis-92, AEB533 Gold Master, AEB535 Blu
Master, AEB536 Red Master, AEB540 Spark Master and AEB547
Cat.
Please, take into account the fact that during the testing phase the
PUMA Timing Advance Processor is programmed with the 515N
software (correspondent to the old model Code AEB540), therefore
you must always check if it is suitable for the car on which it must
be installed.
Enclosed to these instructions, you will find a list of the cars on
which you can install the PUMA Timing Advance Processor with the
relevant indications on the software to be used.
The installation wiring diagrams of every single car instead are
available in our AEB On-Line range; if you do not have it, please
apply to your local dealer.
English
13 - 36
IS515N-1 Rev. 010305-1