Technical Specifications; Safety Regulations - Pinnacle Products International Protemp PT-03-240-GH Manual Del Usuario E Instrucciones De Operación

Introduction
To get the most out of your new ceiling heater,
please read through these instructions and the
attached safety regulations before use. Please
also save the instructions in case you need to
remind yourself of the fan heater's functions or
safety precautions at a later date.
This heater is supplied with a six foot power
cable. If more length is required to reach your
outlet, the grounded outlet must be relocated
by a qualified electrician
Thermostat Instructions
- At first turn the thermostat to "Max" and let the
heater operate with full power input. When the
room temperature reaches the required value,
turn the thermostat counterclockwise until it
switches off.
- The thermostat will then switch on and off
automatically to control the room temperature
according to the preset value and to keep the
room temperature constant.
- When using the heater for the first time, you
may notice a slight emission of smoke. This is
quite normal and it stops after a short time.
The heating element is made of steel and was
coated with a layer of protective oil
during production. The smoke is caused by
the leftover oil as it is heated.

Technical Specifications

Model
PT-03-240-GH
PT-05-240-GH
© 2012, Pinnacle Products International, Inc.
.
Type Voltage ~ Hz /
Ceiling mountable
~60Hz / 15 Amps
Ceiling mountable
~60Hz / 30 Amps
Specifications subject to change without notice
Function Selector Dial
with power settings

Safety Regulations

- Do not connect the fan heater using an
on/off timer or other equipment which can
automatically switch the device on.
- The fan heater must not be placed in
rooms where flammable liquids or gases
are used or stored.
- Children should be supervised to ensure
that they do not play with the appliance.
The appliance in not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge. If the
appliance is damaged, discontinue use.
- Use the appliance in places with good air
ventilation.
- A separate circuit serving only this
appliance must be provided. Keep the
power cable far enough from the hot air
outlet.
- If the supply cable is damaged, it must be
replaced by the manufacturer or service
agent or a similarly qualified person in
order to avoid a hazard.
- The fan heater is not suitable for use out-
doors in damp weather, in bathrooms or in
other wet or damp environments.
- Do not cover the fan heater.
Power Rating
Amps
208-240VAC
3,000
208-240VAC
5,000
4
Electric Fan Heater User's Manual
NEVER LEAVE HEATER
UNATTENDED WHILE
OPERATING
Thermostat Dial
Figure 1. Fan Heater Dials
Heat Settings
1 (3,000W)
2 (2,500-5,000W)