Troubleshooting Guide - Daewoo RC-380BM Manual De Usuario

■ Power cord rewinding
When not in use, unplug from the electrical power outlet and then press the cord
rewinding button to feed back the power cord.
■ For storage
Insert the plastic holder of the Connecting tube into the unit base or
holder hook on the back unit.
■ Put the combination crevice nozzle in the accessory hole in the bottom of the body after
finishing suction.
All manuals and user guides at all-guides.com
8
TROUBLE SHOOTING GUIDE
Please check the following details before you have your appliance repaired in an authorized
■
servicing department.
Problem Possible reason
1. Check if the power plug is firmly
inserted into the outlet.
Motor can't 2. Check if the power switch of the
work appliance is on.
3. Check if the heat sensitive thermostat
be off due to overheating.
1. Check if the hose, floor brush or
Suction
connecting tube is clogged.
power
2. Check if the dust is full;
becomes
3. Check if the air filter is clogged, the
weak
connecting tube is correctly attached.
Power cord
will not fully ■ Check if the power cord is twisted.
feed back
Power cord
can not be ■ The power cord may be twisted.
taken out
■ The inertial rewinding by the cord
Power cord
rewinder device may lead to be out of
rewinds itself
control.
No speed
■ The speed regulation device may be
regulation
out of control
Front cover ■ Check if no dust bag is put inside or
can't be the front cover deformed without dust
closed
bag in good position.
Dust full ■ Check if the floor brush, the hose or
indicator is the long connecting tube is blocked.
covered by red
See if the dust bag is full and the air
indications
filter is clogged.
Solution
1. Insert the plug back again into the outlet to
secure it is switched on.
2. And then turn the power switch on.
3. After the motor be cool off, the unit will
restart working automatically.
1. Immediately remove the obstruction.
2. Empty dust.
3. Clean the dust bag for reassembly of
connecting tubes.
Pull out the power cord at its certain length
and rewind it.
Rewind or pull the cord in or out for several
times by pressing the power cord rewind
button.
Pull the power cord out in for 4-5 times. If
still rewinds itself, ask for an authorized
servicing department for repair.
Restart the appliance for reuse at several
times, if it is exactly out of control, ask for an
authorized servicing department.
Put the dust bag in good position and then
take the appliance to the authorized
servicing department.
Immediately remove obstructions away.
Clean or replace the dust bag. Clean the air
inlet filter.
9