MaxPro MPBDP16 Manual Del Usuario página 11

(3)Screw the tightening screw (5) back down again.
7. Clamping the workpiece
As a general rule, use a machine vice or another suitable clamping device to lock a workpiece into position.
Never hold the workpiece in place with your hand! When drilling, the workpiece should be able to travel
on the drill table (4) for self-centering purposes. Ensure that the workpiece cannot rotate.
This is best achieved by placing the workpiece/machine vice on a sturdy block.
Important! Sheetmetal parts must be clamped in to prevent them from being torn up. Properly set the
height and angle of the drill table for each workpiece. There must be enough distance between the upper
edge of the workpiece and tip of the drill bit.
8. Adjustment of speeds
The spindle speeds can be adjusted by changing the position of v-belt on the pulley when adjusting, mover
the v-belt to required position after releasing the shifter bar, then fasten the shifter bar again as soon as
the v-belt has been adjusted in proper working condition.
Reference list of Drill, Revolution and Various Materials to be Drilled
Drill Diameter
(mm)
Power supply: AC 220-240V 50Hz single phase
The motor can be turned on or off by switch k.
Note: A socket shall be provided for earth connection when arranging sockets, so tha the case of the
machine can be reliably earthed to avoid electric shock.
11
All manuals and user guides at all-guides.com
D D rill Press MPBDP16 User Manual
Steel Cast Iron
1900 1900
1900 1550
1550 1000
1000 800
540 620
450 450
280 450
280 280
Electric Circuit Diagram
Material
Aluminum
Rotative speed R. P. M
2350
1900
1550
1000
800
540
450
450
GB
Plastics Wood
2350 2350
2350 2350
1900 1900
1900 1900
1550 1550
1000 1000
800 800
620 620