Kunft KSM2612 Manual De Instrucciones página 15

6. Put the pulled bobbin thread and upper thread to the left by hand,
7. rotate the hand wheel [27] counter clockwise in order to make
8. Hold the upper thread on the left hand during the rotation of
9. The upper thread will lift the
10. Put the transparent cover [23] on after the bobbin thread and
2.2.9. Introduction to applicable functions
1. Please use them in strict accordance with the following steps in
sewing.
2. on the function indication panel, functions from 1-12 are for
ordinary sewing while functions from 13-16 are for button eyes
sewing. Please choose function 1 and 2 for zipper sewing.
3. The function adjustment wheel [3] is not allowed to rotate when the
machine is running.
4. adjusting the function adjustment wheel [3] requires rotating hand
wheel [27] counter clockwise to lift the sewing needle [17] to the
highest position.
2.2.10. Texture-relative attentions:
1. The machine cannot provide ordinary sewing to elastic textures,
such as towel cloth, lint, elastic knitted fabric, etc.
2. Texture thickness recommended: 0.3 mm-1.8 mm.
2.2.11. Ordinary sewing
1. use the presser foot [37] for ordinary sewing.
2. It requires accomplishing "preparation before operation" step by
step as described in the instructions before sewing.
3. Different stitches of ordinary sewing
can be selected with the function ad-
justment wheel whose numbers cor-
respond to the figure shown on func-
tions indication panel [2], enabling you
to choose different stitches according
to different needs. Please refer to the
following figs. for more information.
Maq-Costura-KSM2612-Manual-2.indd 15
sewing machine
as shown in fig. 6.
the needle move up and down after the bobbin thread and upper
thread have been put to the left, as shown in Fig. 7.
the hand wheel [27] to make the needle move up and down, as
shown in fig. 8.
bobbin thread when the needle
moves down and up. Pull both to
the back and press them under
the presser foot [21] with 10 cm
pulled out, as shown in fig. 9.
upper thread are pressed under the presser foot [21], as shown
in fig. 10.
KSM2612
15
EN
18/02/19 18:34