Operation; Control Panel - J.P. SELECTA DRYGLASS 2000381 Manual De Instrucciones

Estufa para secar vidrio
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MANUAL DE INSTRUCCIONES
3
1
10
7
12
4a
9
J
.P. SELECTA s.a.u.
CODIGO 80025

OPERATION

CONTROL PANEL:

1. Main switch
2. Temperature regulator thermostat
3. Mains indicator lamp (green).
8
4a. Heater operation indicator lamp (amber) 50%.
4b. Heater operation indicator lamp (amber) 100%.
5. [OPTIONAL] 24 hour timer or timer control.
6. Safety thermostat adjustment knob.
7. Safety thermostat indicator lamp.
8. Analog thermometer temperature reader.
9. Locking gear. Thermostat control immobilization device.
11
10. [OPTIONAL] End of cycle signaling lamp.
11. Power selector 50% / 100%.
13
12. Safety thermostat reset push-button.
13. Cyclical or one-time programming selector.
NOTE: The panel shown includes an optional timer supplied
5
as an accessory.
STARTING UP:
1. Press the mains switch (1). The green indicator lamp will light
6
up (3).
2. Turn the temperature control knob (2) clockwise until the working
4b
temperature coincides with the pointer. The amber indicator lamp
(4) will light up.
2
3. Block the temperature control knob (2) with the blockage device
(9) to avoid accidentally moving the knob.
4. After a certain time, the heater operation indicator lamp (4) will
start operating intermittently. When these intermittences become
uniform, the temperature of the oven is stabilized.
5. The thermostat scale is intended as a guide, the real temperature
level inside the oven is the one that the thermometer (8) shows.
* This oven is equipped with a power selector (11) which permits
the use of the oven at 50% or at 100% of its power.
ADJUSTING THE SAFETY THERMOSTAT:
To adjust the safety temperature thermostat, do as follows:
1. With the oven connected to the mains, turn the safety thermostat
control knob (6) clockwise to the end of the scale.
2. Ensure that the safety thermostat is reset by pressing the reset
button (12). The red indicator lamp (7) must be off.
3. Select the desired safety temperature with the temperature
control knob (2). This temperature has to be minimum at 5ºC
above the working temperature.
4. With the door closed, turn on the oven with the switch (1).
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.grupo-selecta.com
REV G
01/2022
Pag.: 13
Tel 34 937 700 877 Fax 34 937 702 362

Publicidad

Tabla de contenido
loading

Tabla de contenido